Microstructure effect on sliding wear of 316L stainless steel selectively laser melted
- 8 January 2024
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 40 (6) , 466-478
Abstract
Due to varying thermal cycles, the resulting microstructure of metal additive manufacturing differs from the conventionally processed counterpart alloys. Since the mechanical properties depend on the microstructure, the wear resistance of components manufactured by laser powder bed fusion (LPBF) is determined by the processing parameters. This work focuses on microhardness and sliding wear of 316L stainless steel, evaluated nanoindentation and pin-on-disc, respectively, analysed through optical microscopy, scanning electron microscopy (SEM), X-ray diffraction (XRD) and glow discharge emission spectrometry (GDOES). The results show that the LPBF-processed specimens have about 40% higher microhardness and ca. 30% lower wear rate than the wrought counterpart. The enhanced sliding wear resistance is associated with the higher density of dislocations at the cellular subgrain boundaries.Keywords
This publication has 47 references indexed in Scilit:
- Rapid fabrication of bulk-form TiB2/316L stainless steel nanocomposites with novel reinforcement architecture and improved performance by selective laser meltingJournal of Alloys and Compounds, 2016
- Effect of metallurgical defect and phase transition on geometric accuracy and wear resistance of iron-based parts fabricated by selective laser meltingJournal of Materials Research, 2016
- Hardened austenite steel with columnar sub-grain structure formed by laser meltingMaterials Science and Engineering: A, 2015
- Effect of Fluid Convection on Dendrite Arm Spacing in Laser DepositionMetallurgical and Materials Transactions B, 2014
- Sliding Wear Characteristics and Corrosion Behaviour of Selective Laser Melted 316L Stainless SteelJournal of Materials Engineering and Performance, 2013
- Movement of Dislocations2011
- Anisotropy changes in hardness and indentation modulus induced by plasma nitriding of 316L polycrystalline stainless steelScripta Materialia, 2011
- Dislocation evolution in 316L stainless steel subjected to uniaxial ratchetting deformationMaterials Science and Engineering: A, 2010
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- Contact and Rubbing of Flat SurfacesJournal of Applied Physics, 1953