Analysis of Different Commercial Solid Fluxes Used During the Rotary Degassing Melt Treatment of Casting Aluminum Alloys
Authors:
Open Access
- 4 December 2024
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions B
- Vol. 56 (1) , 782-797
Abstract
This work aimed to get a better understanding of the behavior and melt cleaning efficiency of different commercial solid fluxes used in the foundry industry for the treatment of liquid aluminum alloys. This was realized by combining industrial melt treatment experiments with the application of characterization techniques that can provide information about the phase composition and thermal stability of different fluxes. Rotary degassing treatments coupled with flux addition using 5 different commercial fluxes were conducted on batches of EN AC-46000 alloy (AlSi9Cu3(Fe)) melt. The melt quality was assessed by the Qualiflash technique and Bifilm-Index (BI) analysis of reduced pressure test (RPT) samples. The phase composition and thermal behavior of the fluxes were investigated by X-ray diffraction (XRD) and differential thermal analysis (DTA), respectively. Among the 5 fluxes, two had a rather similar phase composition with the main constituents being NaCl, KCl, CaF2, MgF2, Na2CO3·NaHCO·3H2O, Na2SO4, and K2SiF6. These two fluxes, which contain a relatively high amount of fluoride components (about 11mol pct), and had a melting temperature below 600 °C, proved to be the most efficient in improving the melt quality. The Quality Temperature Index (QTI) values and normalized Bifilm-Index (NBI) results of the RPT samples generally showed a similar tendency, but there was only a loose relationship between the two parameters. Discrepancies between the results of different melt quality evaluation techniques can be traced back to their sensitivity to melt quality changes.Keywords
Funding Information
- University of Miskolc
This publication has 60 references indexed in Scilit:
- Freezing Range, Melt Quality, and Hot Tearing in Al-Si AlloysMetallurgical and Materials Transactions A, 2018
- Pore Formation During Solidification of Aluminum: Reconciliation of Experimental Observations, Modeling Assumptions, and Classical Nucleation TheoryMetallurgical and Materials Transactions A, 2017
- “Stop Pouring, Start Casting”International Journal of Metalcasting, 2012
- An Evaluation of Quality Parameters for High Pressure Die CastingsInternational Journal of Metalcasting, 2011
- Understanding Quality in Aluminum CastingsInternational Journal of Metalcasting, 2011
- Phase transition in Na2SO4: all five polymorphic transformations in DSCIonics, 2008
- Oxide films, pores and the fatigue lives of cast aluminum alloysMetallurgical and Materials Transactions B, 2006
- Various aspects involved in the production of low-hydrogen aluminium castingsJournal of Materials Science, 1992
- Molten metal processing of advanced cast aluminum alloysJOM, 1991
- Comparison of thermal properties and kinetics of decompositions of NaHCO3 and KHCO3Journal of Thermal Analysis and Calorimetry, 1987