Dynamic testing of horseshoe designs at impact on synthetic and dirt T horoughbred racetrack materials
Authors:
- 20 January 2015
- journal article
- Published by Wiley in Equine Veterinary Journal
- Vol. 48 (1) , 97-102
Abstract
Summary: Reasons for performing study: Different horseshoe designs have been developed in an attempt to optimise footing for equine athletes. Horseshoe performance is assumed to be dependent on the surface and gait, but there are limited data on horseshoe performance on different surfaces, independent of gait variation. Objectives: To quantify the dynamic loading for 3 aluminium racing shoe designs on T horoughbred racetrack surface materials, using a biomechanical surface tester. Study design: A flat racing plate, a serrated V ‐Grip and a shoe with a 6 mm toe grab and 10 mm heel calks were tested on synthetic and dirt surfaces under typical operating conditions of temperature and moisture content for the respective material samples. Methods: Samples were tested under laboratory conditions, replicating a track surface by compacting material into a latex‐lined mould surrounded by silica sand for representative boundary conditions. Peak loading and loading rates were measured vertically and horizontally (craniocaudal), simulating aspects of primary and secondary impacts of the hoof in a galloping horse. Results: Maximum vertical and shear loads and loading rates were not significantly different between shoe types, with the exception of a reduced craniocaudal loading rate for the V ‐Grip shoe on the synthetic surface. All other statistical significance was related to the surface material. Conclusions: These 3 different Thoroughbred racing shoes do not have a significant impact on loading and loading rate, with the exception of the V ‐Grip shoe on a synthetic surface. Although the V ‐Grip may reduce craniocaudal peak load rates in a synthetic material with relatively high wax and/or low oil content, the reduction in load rate is less than the difference found between materials. This study indicates that shoeing has little effect, and that a track's surface material and its preparation have a significant effect on the dynamic loading during the impact phase of the stance.Keywords
Funding Information
- George L. Ohrstom Jr. Foundation Inc.
- Racing Surfaces Testing Laboratory
- Churchill Downs Incorporated Safety from Start to Finish Initiative
This publication has 29 references indexed in Scilit:
- Validation of a Laboratory Method for Evaluating Dynamic Properties of Reconstructed Equine Racetrack SurfacesPLOS ONE, 2012
- Effects of age and loading rate on equine cortical bone failureJournal of the Mechanical Behavior of Biomedical Materials, 2011
- Grip and limb force limits to turning performance in competition horsesProceedings Of The Royal Society B-Biological Sciences, 2010
- Effect of temperature on race times on a synthetic surfaceEquine Veterinary Journal, 2010
- Thermal transitions in high oil content petroleum-based wax blends used in granular sport surfacesThermochimica Acta, 2010
- Hoof accelerations and ground reaction forces of Thoroughbred racehorses measured on dirt, synthetic, and turf track surfacesAmerican Journal of Veterinary Research, 2009
- Risk factors for proximal sesamoid bone fractures associated with exercise history and horseshoe characteristics in Thoroughbred racehorsesAmerican Journal of Veterinary Research, 2007
- Centre of mass movement and mechanical energy fluctuation during gallop locomotion in the Thoroughbred racehorseJournal of Experimental Biology, 2006
- Orthopaedics: Effects of ‘navicular’ shoeing on equine distal forelimb kinematics on different track surfaceVeterinary Quarterly, 2001
- Comparison of the Damping Effect of Different Shoeing by the Measurement of Hoof AccelerationCells Tissues Organs, 1993