The effect of aeration rate and feedstock density on biodrying performance for wet refuse-derived fuel quality improvement
Open Access
- 20 October 2023
- journal article
- research article
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 12 (6) , 1091-1103
Abstract
This study investigates the effect of aeration rate and feedstock density on the biodrying process to improve the quality of type 2 wet refuse-derived fuel. The aeration rate and feedstock density were varied to investigate these parameters’ effect on the system’s performance. The experiments used 0.3 m3 lysimeters with continuous negative ventilation and five days of operation. In Experiment A, aeration rates of 0.4, 0.5, and 0.6 m3/kg/day were tested with a feedstock bulk density of 232 kg/m3. In Experiment B, the optimum aeration rates determined in Experiment A (0.5 and 0.6 m3/kg/day) were used, and the feedstock density was varied (232 kg/m3, 250 kg/m3, and 270 kg/m3). The results showed that an aeration rate of 0.5 m3/kg/day was the most efficient for a feedstock density of 232 kg/m3; when the aeration rate was increased to 0.6 m3/kg/day, a feedstock density of 250 kg/m3 was the most effective. However, a feedstock density of 270 kg/m3 was not found to be practical for use in the quality improvement system. When the feedstock density is increased, the water in the feedstock and the water resulting from the biodegradation process cannot evaporate due to the feedstock layer’s low porosity, and the system requires an increased aeration rate. Furthermore, the increase in density scaled with increased initial volatile solid content, initial organic content, and initial moisture content, which significantly impacted the final moisture content based on multivariate regression analysis.Keywords
Funding Information
- National Research Council of Thailand
- The Joint Graduate School of Energy and Environment, King Mongkut’s University of Technology Thonburi
- the Center of Excellence on Energy Technology and Environment (CEE), Ministry of Higher Education, Science
This publication has 35 references indexed in Scilit:
- Effects of the aeration pattern, aeration rate, and turning frequency on municipal solid waste biodrying performanceJournal of Environmental Management, 2018
- Advances in biodrying technologies for converting organic wastes into solid fuelDrying Technology, 2017
- Effects of adding bulking agents on biostabilization and drying of municipal solid wasteWaste Management, 2017
- The Novel Design and Manufacturing Technology of Densified RDF from Reclaimed Landfill without a Mixing Binding Agent Using a Hydraulic Hot Pressing MachineMATEC Web of Conferences, 2016
- Biodrying process: A sustainable technology for treatment of municipal solid waste with high moisture contentWaste Management, 2016
- Effect of air flow rate and residence time on biodrying of cassava peel wasteInternational Journal of Environmental Technology and Management, 2015
- Influence of forced air volume on water evaporation during sewage sludge bio-dryingWater Research, 2013
- Effect of airflow on biodrying of gardening wastes in reactorsJournal of Environmental Sciences, 2013
- Impact of Alternative Fuels on the Cement Manufacturing Plant Performance: An OverviewProcedia Engineering, 2013
- Moisture, Density, and Porosity Changes as Dairy Manure is Biodried2002