Fully 3D-Printed Microfluidic Sensor Using Substrate Integrated Waveguide Technology for Liquid Permittivity Characterization
- 26 April 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (11) , 10541-10550
Abstract
This paper proposes a fully 3D-printed electromagnetic (EM) microfluidic sensor using rectangular substrate integrated waveguide (SIW) for liquid complex permittivity characterization. The proposed microfluidic sensor is fabricated with a novel additive manufacturing process in which dielectric and conductive inks are simultaneously 3D-printed, allowing high print quality, rapid prototyping, and arbitrary geometry. The fabrication process removes the need for post-printing sintering and cleaning steps that require harmful chemicals. The sensor structure is composed of upper and lower metal plates and a series of cylindrical metal side vias. Since the electric field is high at the center of the SIW cavity in $\textit {TE}_{101}$ mode, a cylindrical dielectric sample container in the form of a microwell is built into the center of the SIW cavity to maximize the perturbation of the liquid under test (LUT). The application of LUT samples to the microwell results in a change in the resonance frequency and peak attenuation from which the LUT sample is characterized. Ethanol-water mixtures are used as LUTs for validation. The proposed sensor has been verified numerically and experimentally, reducing the resonant frequency from 3.750 GHz to 3.862 GHz by increasing the ethanol volume fraction from 0% to 100%. The sensor showed good sensitivity of 0.345% and a stable frequency change was observed over five measurement repetitions. To the best of our knowledge, this article presents the first fully 3D-printed SIW microfluidic sensor and demonstrates its ability to detect and characterize the liquid complex permittivity.Keywords
Funding Information
- Natural Science and Engineering Research Council of Canada
This publication has 48 references indexed in Scilit:
- High-Efficiency Microwave Planar Resonator Sensor Based on Bridge Split Ring TopologyIEEE Microwave and Wireless Components Letters, 2017
- Additively Manufactured RF Components and Modules: Toward Empowering the Birth of Cost-Efficient Dense and Ubiquitous IoT ImplementationsProceedings of the IEEE, 2017
- A Microfluidic-Integrated SIW Lab-on-Substrate Sensor for Microliter Liquid CharacterizationIEEE Sensors Journal, 2016
- An SIW Resonator Sensor for Liquid Permittivity Measurements at C BandIEEE Microwave and Wireless Components Letters, 2015
- Exploiting 3D printed substrate for microfluidic SIW sensor2015
- 3D Printing for the Rapid Prototyping of Structural ElectronicsIEEE Access, 2014
- Improved Split-Ring Resonator for Microfluidic SensingIEEE Transactions on Microwave Theory and Techniques, 2014
- High-Sensitivity Metamaterial-Inspired Sensor for Microfluidic Dielectric CharacterizationIEEE Sensors Journal, 2013
- A Microwave and Microfluidic Planar Resonator for Efficient and Accurate Complex Permittivity Characterization of Aqueous SolutionsIEEE Transactions on Microwave Theory and Techniques, 2012
- Microwave dielectric characterization of binary mixtures of water, methanol, and ethanolThe Journal of Chemical Physics, 1996