Contraction velocity of viscoelastic filaments
- 26 December 2022
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 7 (12) , L121601
Abstract
Liquid filaments, which are commonplace in daily life, nature, and technology, including inkjet printing and crop spraying, contract due to surface tension: they either retract into a single sphere or break up to produce a primary drop(s) and several smaller satellites. The latter are undesirable because they reduce printing quality and cause pollution due to spray drift. Surfactants and/or polymer additives can be used to control filament contraction and breakup. It has recently been demonstrated experimentally that the velocity at which the tips of contracting filaments retract can be increased in viscoelastic filaments that contain polymer additives compared to purely Newtonian filaments. Here, simulations are used to investigate the contraction of viscoelastic filaments whose rheology is described by the Oldroyd-B model. Filaments produced from nozzles are expected to be prestressed when they begin to contract. It is shown that the velocity with which the tips of prestressed filaments retract is greatly increased compared to filaments in which the polymer molecules are relaxed. This enhancement is explained by examining the value of (: Elastic stress; : Rate-of-strain tensor), which can be positive or negative. This quantity is positive when the flow does work on the polymer molecules but negative when the molecules do work on the flow, i.e., when elastic recoiling or unloading takes place. In prestressed filaments, elastic unloading takes place because : The elastic stresses work by pulling the fluid in axially and pushing it out radially, thereby drastically increasing the tip velocity.
Keywords
Funding Information
- Purdue Process Safety and Assurance Center
This publication has 52 references indexed in Scilit:
- The dynamics of the piezo inkjet printhead operation☆Physics Reports, 2010
- Dynamics of viscoelastic liquid filaments: Low capillary number flowsJournal of Non-Newtonian Fluid Mechanics, 2008
- Physics of liquid jetsReports on Progress in Physics, 2008
- The beads-on-string structure of viscoelastic threadsJournal of Fluid Mechanics, 2006
- The effect of added polymers on the formation of drops ejected from a nozzlePhysics of Fluids, 2005
- On the evolution and rupture of filaments in Giesekus and FENE modelsJournal of Non-Newtonian Fluid Mechanics, 2004
- Free surface flows of polymer solutions with models based on the conformation tensorJournal of Non-Newtonian Fluid Mechanics, 2002
- On the bursting of viscous filmsPhysics of Fluids, 1999
- An experimental study of transient effects in the breakup of viscous dropsJournal of Fluid Mechanics, 1986
- Nonlinear analysis of the surface tension driven breakup of viscoelastic filamentsJournal of Non-Newtonian Fluid Mechanics, 1986