Reliability of Ag Sintering for Power Semiconductor Die Attach in High-Temperature Applications
Authors:
Top Cited Papers
- 21 November 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 32 (9) , 7083-7095
Abstract
Low-temperature Ag sintering provides a lead-free die attachment method that is compatible with high-temperature (300 °C) power electronics applications. The reliability of sintered Ag die attach for Si and SiC die has been studied on both thick film substrates for lower current power applications and direct bond copper (DBC) substrates for higher current power applications. Pressureless and low-pressure sintering were evaluated. Sintering with low pressure yielded lower porosity (15-17%) versus pressureless sintering (~30%). Reliability was evaluated with thermal aging (300 °C) and thermal cycling (-55 °C to + 300 °C) tests. Reliable Ag sintered die attach was achieved with assemblies having Ag-bearing surface finishes on both the die and the substrate. In contrast, the shear strength after 300 °C aging was greatly reduced when Au metallization was used either on the die or on substrate surface. In some cases, low-pressure sintering delayed the failure of the sintered Ag die attach to Au surfaces when aged at 300 °C compared to the pressureless sintering. The reliability with Pd-containing substrate metallizations was intermediate between Ag and Au metallizations. The thermal cycle reliability on DBC substrates was limited by failure at the Cu-to-alumina interface over the wide temperature range, while on the thick film substrates high adhesion was maintained after 1000 thermal cycles.Keywords
This publication has 25 references indexed in Scilit:
- Low Temperature, Fast Sintering of Micro-Scale Silver Paste for Die Attach for 300°C ApplicationsInternational Symposium on Microelectronics, 2015
- Sintering of Ag paste for power devices die attach on Cu surfaces2014
- Chip-Bonding on Copper by Pressureless Sintering of Nanosilver Paste Under Controlled AtmosphereIEEE Transactions on Components, Packaging and Manufacturing Technology, 2014
- Strength and Reliability of High Temperature Transient Liquid Phase Sintered JointsAdditional Conferences (Device Packaging, Hitec, Hiten, & Cicmt), 2014
- Reliability assessment of sintered nano-silver die attachment for power semiconductors2010
- Characteristics of Zn-Al-Cu Alloys for High Temperature Solder ApplicationMATERIALS TRANSACTIONS, 2008
- Thermodynamic Assessments of the Ag-Ni Binary and Ag-Cu-Ni Ternary SystemsJournal of Electronic Materials, 2007
- Power Device Packaging Technologies for Extreme EnvironmentsIEEE Transactions on Electronics Packaging Manufacturing, 2007
- Advantages and new development of direct bonded copper substratesMicroelectronics Reliability, 2003
- Reliability Study of Wire Bonds to Silver Plated SurfacesIEEE Transactions on Parts, Hybrids, and Packaging, 1977