Electron beam additive manufacturing of TiCx/Ti-6Al-4V composite
Authors:
- Artem BuilukABArtem Builuk
- Marina KazachenokMKMarina Kazachenok
- Sergey MartynovSMSergey Martynov
- 19 November 2019
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2167 (1) , 020039
Abstract
In this paper, the technology of simultaneous electron beam melting of the titanium alloy wire of Ti-6Al-4V and TiC powder was developed. The effect of 3D printing parameters on the microstructure and mechanical properties of TiCх/Ti-6Al-4V composites was also investigated. Simultaneous feeding of the Ti-6Al-4V wire and the TiCx/Ti-6Al-4V mechano-composite leads to a change in the microstructure of the 3D-printed samples. Such a change in the microstructure leads to a significant increase in the microhardness and mechanical characteristics under tension. The maximum ultimate tensile strength (950 MPa) and ductility (6%) are achieved with the introduction of the mechano-composite TiC15wt%/Ti-6Al-4V.This publication has 5 references indexed in Scilit:
- Effect of TiC particle size on the microstructure and tensile properties of TiCp/Ti6Al4V composites fabricated by laser melting depositionOptics & Laser Technology, 2018
- Microstructure and mechanical properties of functionally graded TiCp/Ti6Al4V composite fabricated by laser melting depositionCeramics International, 2017
- Additive manufacturing of metalsActa Materialia, 2016
- Rapid preparation of TiC reinforced Ti6Al4V based composites by carburizing method through spark plasma sintering techniqueMaterials & Design (1980-2015), 2015
- Influence of phase interface properties on mechanical characteristics of metal ceramic compositesPhysical Mesomechanics, 2014