Research on damage evolution mechanisms under compressive and tensile tests of plain weave SiC f /SiC composites using in situ X-ray CT
Open Access
- 1 January 2024
- journal article
- research article
- Published by Walter de Gruyter GmbH in Science and Engineering of Composite Materials
- Vol. 31 (1)
Abstract
To investigate the damage evolution and failure mechanisms of fiber-reinforced composite materials under complex conditions, this study conducted in situ X-ray computed tomography (CT) compression and tensile tests on plain weave two-dimensional woven SiC/SiC composite materials. The obtained CT in situ image data captured the behavior of materials during loading and after failure. Using the image reconstruction of CT data, the actual microstructure and damage evolution of the material under six consecutive loading levels were accurately revealed. Three-dimensional visualization models of the composite material were established using image processing software to analyze the damage evolution under compression and tension, and the failure mechanisms were compared. The results showed that the compression and tension failure mechanisms of SiC/SiC composite materials were similar, with the transverse cracking of the matrix being the first mode of damage, followed by delamination between layers and longitudinal matrix cracking of fiber bundles. Specifically, in terms of compression failure, the strength of the fiber bundle itself has a greater influence, and fiber fracture is the main cause of ultimate material failure. On the other hand, the primary cause of tensile failure is the presence of porosity defects generated during material fabrication. Consequently, the tensile material fails earlier and can withstand lower loads.Keywords
This publication has 31 references indexed in Scilit:
- Quantifying the three-dimensional damage and stress redistribution mechanisms of braided SiC/SiC composites by in situ volumetric digital image correlationScripta Materialia, 2017
- Mechanical behavior of C/SiC composites under hypervelocity impact at different temperatures: Micro-structures, damage and mechanismsComposites Part A: Applied Science and Manufacturing, 2016
- Advanced structural ceramics in aerospace propulsionNature Materials, 2016
- The microstructure and properties of SiC/SiC-based composites fabricated by low-temperature melt infiltration of Al–Si alloyCeramics International, 2016
- Prediction of stress–strain and fracture behaviour of an 8-Harness satin weave ceramic matrix compositeInternational Journal of Solids and Structures, 2014
- Tensile testing of materials at high temperatures above 1700 °C with in situ synchrotron X-ray micro-tomographyReview of Scientific Instruments, 2014
- Studying SiC/SiC Composites by X-Ray TomographyKey Engineering Materials, 2014
- Real-time quantitative imaging of failure events in materials under load at temperatures above 1,600 °CNature Materials, 2012
- Micro-CT characterization on porosity structure of 3D Cf/SiCm compositeComposites Part A: Applied Science and Manufacturing, 2011
- In situ X-ray microtomography characterization of damage in SiCf/SiC minicompositesComposites Science and Technology, 2011