On-Line Characterization of Bulk Permeability and Race-Tracking During the Filling Stage in Resin Transfer Molding Process
- 1 September 2003
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 37 (17) , 1525-1541
Abstract
Resin Transfer Molding (RTM) is widely used to manufacture polymer composite materials. In this process, the fiber preform is placed in a closed mold and thermoset resin is injected to saturate the preform. After the resin cures the mold is opened and the net shape composite part is obtained. With RTM, one is capable of making complex and high quality composite parts with short cycle times. However, by introducing more complexity into the part, one also introduces higher probability of disturbances, such as race-tracking of resin during impregnation along preform edges. This can lead to incomplete saturation of fiber preform forming flaws such as dry spots in the composite part. The strength and existence of race-tracking is a function of the fabric type, perform manufacturing method, and their placement in the mold. It can vary from one part to the next in the same production run and usually it is not repeatable. The characterization of race-tracking and preform permeability is a key input for simulation tools that optimize the gates and vents locations and for designing advanced sensing and flow control strategies. This paper describes a method to estimate the strength and location of race-tracking and characterize the preform bulk permeability during the resin impregnation stage of RTM. The approach can be described in two steps. The first step generates simulations off line that map the overall range of potential disturbances likely to occur during the injection. The second step uses sensors placed in the mold, which allow one to identify the simulation within the database that resembles the experiment in terms of the filling behavior during the filling stage on the manufacturing platform. In the final step, this information is used to estimate race-tracking strength and location as well as the bulk permeability. Both experimental and numerical case studies show the reliability and accuracy of this method. It could be utilized for a broad range of applications such as active flow control, vent location optimization, and process monitoring of mold filling processes.Keywords
This publication has 25 references indexed in Scilit:
- A Method to Determine 3D Permeability of Fibrous ReinforcementsJournal of Composite Materials, 2002
- Fractal permeation characteristics of preforms used in liquid composite moldingPolymer Composites, 2000
- Characterization and modeling of race-tracking in liquidcomposite molding processesComposites Science and Technology, 1999
- Use of genetic algorithms to optimize gate and vent locations for the resin transfer molding processPolymer Composites, 1999
- Sensor Based Modeling and Control of Fluid Flow in Resin Transfer MoldingJournal of Materials Processing & Manufacturing Science, 1998
- A nonlinear control method for resin transfer moldingPolymer Composites, 1997
- Interpretation of 3‐D permeability measurements for RTM modelingPolymer Composites, 1995
- A numerical approach to model non‐isothermal viscous flow through fibrous media with free surfacesInternational Journal for Numerical Methods in Fluids, 1994
- Performing analysis of thermoformable glass fiber mats—deformation modes and reinforcement characterizationPolymer Composites, 1994
- A finite element/control volume approach to mold filling in anisotropic porous mediaPolymer Composites, 1990