Dual‐energy CT‐based stopping power prediction for dental materials in particle therapy
Open Access
- 9 April 2023
- journal article
- research article
- Published by Wiley in Journal of Applied Clinical Medical Physics
- Vol. 24 (8) , e13977
Abstract
Radiotherapy with protons or light ions can offer accurate and precise treatment delivery. Accurate knowledge of the stopping power ratio (SPR) distribution of the tissues in the patient is crucial for improving dose prediction in patients during planning. However, materials of uncertain stoichiometric composition such as dental implant and restoration materials can substantially impair particle therapy treatment planning due to related SPR prediction uncertainties. This study investigated the impact of using dual‐energy computed tomography (DECT) imaging for characterizing and compensating for commonly used dental implant and restoration materials during particle therapy treatment planning. Radiological material parameters of ten common dental materials were determined using two different DECT techniques: sequential acquisition CT (SACT) and dual‐layer spectral CT (DLCT). DECT‐based direct SPR predictions of dental materials via spectral image data were compared to conventional single‐energy CT (SECT)‐based SPR predictions obtained via indirect CT‐number‐to‐SPR conversion. DECT techniques were found overall to reduce uncertainty in SPR predictions in dental implant and restoration materials compared to SECT, although DECT methods showed limitations for materials containing elements of a high atomic number. To assess the influence on treatment planning, an anthropomorphic head phantom with a removable tooth containing lithium disilicate as a dental material was used. The results indicated that both DECT techniques predicted similar ranges for beams unobstructed by dental material in the head phantom. When ion beams passed through the lithium disilicate restoration, DLCT‐based SPR predictions using a projection‐based method showed better agreement with measured reference SPR values (range deviation: 0.2 mm) compared to SECT‐based predictions. DECT‐based SPR prediction may improve the management of certain non‐tissue dental implant and restoration materials and subsequently increase dose prediction accuracy.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft
This publication has 48 references indexed in Scilit:
- Experimental verification of ion range calculation in a treatment planning system using a flat-panel detectorPhysics in Medicine & Biology, 2014
- Experimental verification of ion stopping power prediction from dual energy CT data in tissue surrogatesPhysics in Medicine & Biology, 2013
- Dosimetric accuracy of proton therapy for chordoma patients with titanium implantsMedical Physics, 2013
- The dosimetric impact of dental implants on head-and-neck volumetric modulated arc therapyPhysics in Medicine & Biology, 2013
- Range uncertainties in proton therapy and the role of Monte Carlo simulationsPhysics in Medicine & Biology, 2012
- CT metal artifact reduction method correcting for beam hardening and missing projectionsPhysics in Medicine & Biology, 2012
- Metal artifact reduction by dual energy computed tomography using monoenergetic extrapolationEuropean Radiology, 2011
- Theoretical variance analysis of single- and dual-energy computed tomography methods for calculating proton stopping power ratios of biological tissuesPhysics in Medicine & Biology, 2010
- The influence of metal artefacts on the range of ion beamsPhysics in Medicine & Biology, 2007
- The calibration of CT Hounsfield units for radiotherapy treatment planningPhysics in Medicine & Biology, 1996