Telecentric Imaging-Based Dimensional Measurement for Rotational Components With Magnification and Edge Localization Error Correction
- 22 September 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-9
Abstract
To ensure high accuracy in measuring the diameters of rotational components, this study presents a measurement method based on a telecentric imaging system with magnification and edge localization error correction. A rotational component diameter measurement system is designed, where projection images of the axial cross section of the measured component are captured using an area-scan camera equipped with a bilateral telecentric lens. A calibration method involving both a standard sphere and a pin gauge is proposed to accurately correct magnification and edge localization errors of the system. The diameter measurement results are then obtained by incorporating these error corrections. The effectiveness of the proposed method is demonstrated by measuring two pin gauges with diameters of 12.5 and 7.5 mm, as well as a 20-mm steel ball. Compared to the precalibration results, the measurement error decreased by 0.0350, 0.0424, and 0.0332 mm. In addition, compared with the checkerboard calibration method, the proposed method demonstrated an error reduction of 0.0006, 0.0012, and 0.0024 mm. The proposed method can be extended to telecentric optical imaging measurements for other geometric parameters.Keywords
Funding Information
- National Key Research and Development Program of China (2024YFF0726600, 2024YFF0726601)
- National Natural Science Foundation of China (51975158)
- Natural Science Foundation of Heilongjiang Province (LH2020E041)
- Fundamental Research Funds for the Central Universities (XNAUEA5750302321)
This publication has 33 references indexed in Scilit:
- A calibration method for telecentric line-scan cameras with an enhanced dynamic imaging model and initial estimates derived from direct linear transformationMeasurement, 2024
- Adaptive fault diagnosis method for rotating machinery with unknown faults under multiple working conditionsJournal of Manufacturing Systems, 2022
- Three-dimensional measurement of precise shaft parts based on line structured light and deep learningMeasurement, 2022
- A novel cylindrical profile measurement model and errors separation method applied to stepped shafts precision model engineeringMeasurement, 2022
- An online visual measurement method for workpiece dimension based on deep learningMeasurement, 2021
- A Multi-view Camera Model for Line-Scan Cameras with Telecentric LensesJournal of Mathematical Imaging and Vision, 2021
- Gaussian bilateral filtered discrete Hartley feature transformation based infomax boosting for hyperspectral image classificationInternational Journal of Intelligent Networks, 2021
- A Camera Model for Line-Scan Cameras with Telecentric LensesInternational Journal of Computer Vision, 2020
- Telecentricity based measurement error compensation in the bilateral telecentric systemMeasurement, 2019
- Sphericity measurement through a new minimum zone algorithm with error compensation of point coordinatesMeasurement, 2019