ResistaMet GUI is a desktop application for electrical characterization using Keithley 2400 series source measure units (SMUs) over a GPIB interface. These instruments are commonly used by electrical engineers, materials scientists, and other physical scientists to characterize electrically active devices and materials. This software is benchwritten and tested with 6 primary measurement modes: two-and four-wire resistance, constant-voltage and constantcurrent biasing for long runs (with in-run event annotations), I-V sweep, collinear 4-point probe per ASTM F84, and van der Pauw per ASTM F76 Method A. Each reading carries an instrument uncertainty propagated from the Keithley datasheet’s per-range accuracy specs, all the way through to derived quantities like sheet resistance and resistivity. An in-package Keithley simulator, calibrated against captured SCPI traces from our bench Keithley 2420 and replayed in CI, allows users to test and practice each mode without an SMU, and keeps documented hardware quirks from regressing.