Fracture Resistance of Pressed and Milled Lithium Disilicate Anterior Complete Coverage Restorations Following Endodontic Access Preparation
- 22 April 2018
- journal article
- research article
- Published by Wiley in Journal of Prosthodontics
- Vol. 28 (2) , 163-170
Abstract
Purpose: This in vitro study evaluated the fracture resistance and clinical prognosis of anterior lithium disilicate crowns (e.max Press and e.max CAD), following endodontic access and repair. The research design simulates intraoral loading conditions to produce clinically applicable results.Materials and Methods: Monolithic anterior crowns, based on #8 anatomy, were fabricated from e.max Press ingots and e.max CAD blocks and adhesively bonded on identical dies milled out of a dentin analog material (NEMA G10). Specimens were divided into 4 groups: intact pressed, repaired pressed, intact milled, and repaired milled (n = 15/group). Repaired pressed and repaired milled were prepared with a standardized endodontic access and repaired using a porcelain repair system and composite resin. All crowns were cyclically loaded under simulated oral conditions and then loaded to failure in water, using a universal testing machine. Data were interpreted using ANOVA/Tukey post‐hoc test (α = 0.05).Results: Mean loads to failure ranged from 758.9 to 931.4 N for the 4 groups, indicating that both fabrication techniques, pressed and milled, yielded restorations that could reasonably withstand maximum masticatory forces. The pressed groups (923.7 N) exhibited significantly higher fracture resistance than the milled groups (797.5 N), p = 0.0002. When milled and pressed groups were categorized into intact and repaired subgroups, no difference was found in fracture resistance between the subgroups. Differences were noted in the modes of fracture, where the milled groups (intact and repaired) exhibited higher frequency of catastrophic fractures than the pressed groups.Conclusions: Endodontic access preparation does not appear to affect fracture resistance of an anterior lithium disilicate restoration, suggesting that replacement may not be necessary. Fabrication technique had a significant effect on fracture resistance and fracture mode of lithium disilicate restorations. The pressed fabrication technique resulted in significantly greater crown strength and fracture resistance than the milled technique.Keywords
Funding Information
- American College of Prosthodontists Education Foundation (ACPEF) Research Fellowship Grant
This publication has 32 references indexed in Scilit:
- A Six Year Evaluation of Cracked Teeth Diagnosed with Reversible Pulpitis: Treatment and PrognosisJournal of Endodontics, 2007
- A systematic review of the survival and complication rates of all‐ceramic and metal–ceramic reconstructions after an observation period of at least 3 years. Part I: single crownsClinical Oral Implants Research, 2007
- Fate of vital pulps beneath a metal‐ceramic crown or a bridge retainerInternational Endodontic Journal, 2005
- Clinical complications in fixed prosthodonticsThe Journal of Prosthetic Dentistry, 2003
- Microleakage—Full crowns and the dental pulpJournal of Endodontics, 1992
- Pulpal evaluation of teeth restored with fixed prosthesesThe Journal of Prosthetic Dentistry, 1992
- Reduction in tooth stiffness as a result of endodontic and restorative proceduresJournal of Endodontics, 1989
- The Effect of Thermal Stress on the Marginal Seal of Cast Gold Full CrownsThe Journal of the American Dental Association, 1980
- Pulp lability and repair; effect of restorative proceduresOral Surgery, Oral Medicine, Oral Pathology, 1972
- Pulp response to externally applied heatOral Surgery, Oral Medicine, Oral Pathology, 1965