Study of the influence of cutting parameters on surface quality in AWJM machining of thermoplastic matrix composites
Authors:
- Fermin BañonFermin Bañon
- Alejandro SambrunoASAlejandro Sambruno
- Raul Ruiz-GarciaRRRaul Ruiz-Garcia
- Jorge SalgueroJSJorge Salguero
- Pedro F. MayuetPMPedro F. Mayuet
Open Access
- 1 January 2019
- journal article
- Published by Elsevier in Procedia Manufacturing
- Vol. 41, 233-240
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- Overview of automotive structural composites technology developments in JapanComposites Science and Technology, 2018
- Experimental investigation and optimization of abrasive water jet cutting parameters for the improvement of cut quality in carbon fiber reinforced plastic laminatesJournal of Industrial Textiles, 2017
- INTERNAL DAMAGE EVALUATION OF CFRTP CUT BY A CIRCULAR SAW2017
- SOM/SEM based Characterization of Internal Delaminations of CFRP Samples Machined by AWJMProcedia Engineering, 2015
- Ultrafast Feed Drilling of Carbon Fiber-Reinforced ThermoplasticsProcedia CIRP, 2015
- Minimization of Kerf Taper Angle and Kerf Width Using Taguchi's Method in Abrasive Water Jet Machining of MarbleProcedia Materials Science, 2014
- High Energy Fluid Jet Machining (HEFJet-Mach): From scientific and technological advances to niche industrial applicationsCIRP Annals, 2014
- DEVELOPMENT OF A CUTTING TOOL FOR COMPOSITES WITH THERMOPLASTIC MATRIXMM Science Journal, 2013
- Composite Cutting with Abrasive Water JetProcedia Engineering, 2013
- Drilling of long fiber reinforced thermoplastics—Influence of the cutting edge on the machining resultsCIRP Annals, 2011