Partial discharge location in power cables using a phase difference method
Authors:
- 6 December 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 17 (6) , 1738-1746
Abstract
This paper presents a new partial discharge (PD) location technique for power cables. Unlike commonly used time-domain reflectometry (TDR) methods, this technique is based on the analysis of phase difference between the direct and reflected waves of a PD pulse measured at the cable end. The phase difference at various frequencies can be obtained from the cross Fourier spectral density function. After implementing a phase unwrapping algorithm, the defect is located. This technique has been tested using the Electromagnetic Transient Program (EMTP) on the model of a 20 kV, 1-km underground cable. The simulation takes into account the frequency-dependent parameters of the cable and the measurement accuracy of the A/D converter (8-bit). The signal-to-noise ratio (SNR) varies from 10 dB to -5 dB for all computer simulations. The statistical results are given to demonstrate the performance of the proposed technique.Keywords
This publication has 18 references indexed in Scilit:
- De-noising of partial discharge signal using eigen-decomposition techniqueIEEE Transactions on Dielectrics and Electrical Insulation, 2008
- Partial Discharge Pulse Propagation in Shielded Power Cable and Implications for Detection SensitivityIEEE Electrical Insulation Magazine, 2007
- Semiconducting layer as an attractive PD detection sensor of XLPE cablesIEEE Transactions on Dielectrics and Electrical Insulation, 2006
- Calculation of frequency-dependent parameters of power cables: matrix partitioning techniquesIEEE Transactions on Power Delivery, 2002
- Performance limits of PD location based on time-domain reflectometryIEEE Transactions on Dielectrics and Electrical Insulation, 1997
- Partial discharge. XXII. High frequency attenuation in shielded solid dielectric power cable and implications thereof for PD locationIEEE Electrical Insulation Magazine, 1996
- Partial discharge. XVIII. Errors in the location of partial discharges in high voltage solid dielectric cablesIEEE Electrical Insulation Magazine, 1993
- Location of partial discharges in shielded cables in the presence of high noiseIEEE Transactions on Electrical Insulation, 1992
- Simulation of transients in underground cables with frequency-dependent modal transformation matricesIEEE Transactions on Power Delivery, 1988
- Time delay estimation using phase dataIEEE Transactions on Acoustics, Speech, and Signal Processing, 1981