Large-Eddy Simulation With Zonal Near Wall Treatment of Flow and Heat Transfer in a Ribbed Duct for the Internal Cooling of Turbine Blades
- 25 March 2013
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (3) , 031006
Abstract
Large eddy simulations of flow and heat transfer in a square ribbed duct with rib height to hydraulic diameter of 0.1 and 0.05 and rib pitch to rib height ratio of 10 and 20 are carried out with the near wall region being modeled with a zonal two layer model. A novel formulation is used for solving the turbulent boundary layer equation for the effective tangential velocity in a generalized co-ordinate system in the near wall zonal treatment. A methodology to model the heat transfer in the zonal near wall layer in the large eddy simulations (LES) framework is presented. This general approach is explained for both Dirichlet and Neumann wall boundary conditions. Reynolds numbers of 20,000 and 60,000 are investigated. Predictions with wall modeled LES are compared with the hydrodynamic and heat transfer experimental data of (Rau et al. 1998, “The Effect of Periodic Ribs on the Local Aerodynamic and Heat Transfer Performance of a Straight Cooling Channel,”ASME J. Turbomach., 120, pp. 368–375). and (Han et al. 1986, “Measurement of Heat Transfer and Pressure Drop in Rectangular Channels With Turbulence Promoters,” NASA Report No. 4015), and wall resolved LES data of Tafti (Tafti, 2004, “Evaluating the Role of Subgrid Stress Modeling in a Ribbed Duct for the Internal Cooling of Turbine Blades,” Int. J. Heat Fluid Flow 26, pp. 92–104). Friction factor, heat transfer coefficient, mean flow as well as turbulent statistics match available data closely with very good accuracy. Wall modeled LES at high Reynolds numbers as presented in this paper reduces the overall computational complexity by factors of 60–140 compared to resolved LES, without any significant loss in accuracy.Keywords
This publication has 37 references indexed in Scilit:
- Comparison between laminar and turbulent heat transfer in a stationary square duct with transverse or angled rib turbulatorsInternational Journal of Heat and Mass Transfer, 2001
- Detailed mass transfer distribution in a ribbed coolant passage with a 180° bendInternational Journal of Heat and Mass Transfer, 2000
- Rib Heat Transfer Coefficient Measurements in a Rib-Roughened Square PassageJournal of Turbomachinery, 1998
- The Effect of Periodic Ribs on the Local Aerodynamic and Heat Transfer Performance of a Straight Cooling ChannelJournal of Turbomachinery, 1998
- Detailed heat transfer distributions in two-pass square channels with rib turbulatorsInternational Journal of Heat and Mass Transfer, 1997
- Influence of Surface Heat Flux Ratio on Heat Transfer Augmentation in Square Channels With Parallel, Crossed, and V-Shaped Angled RibsJournal of Turbomachinery, 1992
- Effect of Rib-Angle Orientation on Local Mass Transfer Distribution in a Three-Pass Rib-Roughened ChannelJournal of Turbomachinery, 1991
- Heat Transfer and Friction Characteristics in Rectangular Channels With Rib TurbulatorsJournal of Heat Transfer, 1988
- Effect of Rib Angle on Local Heat/Mass Transfer Distribution in a Two-Pass Rib-Roughened ChannelJournal of Turbomachinery, 1988
- Local Heat/Mass Transfer Distributions Around Sharp 180 deg Turns in Two-Pass Smooth and Rib-Roughened ChannelsJournal of Heat Transfer, 1988