Patterns of Difference between Physical and 1-D Calibrated Effective Roughness Parameters in Mountain Rivers
Open Access
Abstract
Due to the presence of boulders and different morphologies, mountain rivers contain various resistance sources. To correctly simulate river flow using 1-D hydrodynamic models, an accurate estimation of the flow resistance is required. In this article, a comparison between the physical roughness parameter (PRP) and effective roughness coefficient (ERC) is presented for three of the most typical morphological configurations in mountain rivers: cascade, step-pool, and plane-bed. The PRP and its variation were obtained through multiple measurements of field variables and an uncertainty analysis, while the ERC range was derived with a GLUE procedure implemented in HEC-RAS, a 1-D hydrodynamic model. In the GLUE experiments, two modes of the Representative Friction Slope Method (RFSM) between two cross-sections were tested, including the variation in the roughness parameter. The results revealed that the RFSM effect was limited to low flows in cascade and step-pool. Moreover, when HEC-RAS selected the RSFM, only acceptable results were presented for plane-bed. The difference between ERC and PRP depended on the flow magnitude and the morphology, and as shown in this study, when the flow increased, the ERC and PRP ranges approached each other and even overlapped in cascade and step-pool. This research aimed to improve the roughness value selection process in a 1-D model given the importance of this parameter in the predictability of the results. In addition, a comparison was presented between the results obtained with the numerical model and the values calculated with the field measurementsKeywords
Funding Information
- Research Directorate of the University of Cuenca (XVIII competition of research projects)
This publication has 27 references indexed in Scilit:
- Uncertainty Quantification in Flood Inundation Mapping Using Generalized Likelihood Uncertainty Estimate and Sensitivity AnalysisJournal of Hydrologic Engineering, 2012
- Effect of topographic data, geometric configuration and modeling approach on flood inundation mappingJournal of Hydrology, 2009
- Generalized likelihood uncertainty estimation (GLUE) using adaptive Markov Chain Monte Carlo samplingAdvances in Water Resources, 2008
- The concept of roughness in fluvial hydraulics and its formulation in 1D, 2D and 3D numerical simulation modelsJournal of Hydraulic Research, 2008
- Uncertainty in the calibration of effective roughness parameters in HEC-RAS using inundation and downstream level observationsJournal of Hydrology, 2005
- Evaluation of 1D and 2D numerical models for predicting river flood inundationJournal of Hydrology, 2002
- Velocity and flow resistance in step-pool streamsGeomorphology, 2002
- Assessing the uncertainty in distributed model predictions using observed binary pattern information within GLUEHydrological Processes, 2002
- Uncertainty and equifinality in calibrating distributed roughness coefficients in a flood propagation model with limited dataAdvances in Water Resources, 1998
- The future of distributed models: Model calibration and uncertainty predictionHydrological Processes, 1992