Dependency of the porosity and the layer thickness on the reliability of Ag sintered joints during active power cycling
Authors:
- 1 May 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 1866-1873
Abstract
In order to analyze the reliability of Ag sintered joints in dependency of their porosity and their layer thickness, Si IGBTs were mounted on DCB substrates via Ag sintering by applying a certain pressure as well as conducting pressure-less sintering. The assemblies were subjected to active power cycling tests at which the electric current was controled such that the die attach was exposed to temperatures from +30 °C up to +180 °C. The results show that depending on the applied pressure and the initial layer thickness Ag sintered joints exhibit a 10 to 100 times higher lifetime than standard SnAg3.5 solder joints. Furthermore, the analyses of cross sections show that the occurring failures of the thermomechanically treated Ag sintered joints are deviating from those of soldered joints which fail due to creep fatigue solely. It is also shown that the occurring failures can be detected non-destructively by combining X-ray and ultrasonic-microscopy.Keywords
This publication has 3 references indexed in Scilit:
- Novel interconnect materials for high reliability power converters with operation temperatures above 150°C2012
- Assessment of thermo-mechanical stresses in Low Temperature Joining Technology2012
- Thermo-Mechanical Reliability of Nano-Silver Sintered Joints versus Lead-Free Solder Joints for Attaching Large-Area Silicon DevicesSAE International Journal of Advances and Current Practices in Mobility, 2010