Experimental Study on Femtosecond Laser Processing Performance of Single-Crystal Silicon Carbide
Open Access
- 26 June 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (13) , 7533
Abstract
Femtosecond laser processing technology offers a promising technique for the preparation of micro and nanostructures of single-crystal silicon carbide (SiC), thanks to its high precision and non-destructive processing. However, further research is needed to optimize processing parameters, as well as improve efficiency and quality of the process. This study conducts experiments to explore the effects of femtosecond laser ablation on single-crystal SiC. The influence and significance of parameters, such as fluence (F), repetition rate, scan speed (S), multipass scanning (c) and numerical aperture on the performance of grooves, including groove depth, groove width, heat-affected zone (HAZ) width, material removal rate (MRR) and side wall inclination angle, were studied. The results show that the influence of fluence and numerical aperture on groove depth, groove width, HAZ width, MRR and side wall inclination angle is very significant. The scan speed has a very significant effect on the groove depth, groove width, HAZ width and side wall inclination angle but has insignificant effect on the MRR. Repetition rate and multipass scanning have a very significant effect on groove depth, HAZ width, MRR and side wall inclination angle and a moderately significant effect on groove width. The experimental methods of increasing the aspect ratio and reducing the HAZ width were studied, and a significance analysis was carried out. Fluence, multipass scanning and z-layer feed have significant effects on groove depth, groove width, aspect ratio, HAZ width and MRR. The influence of polarization angle on groove depth, groove width, aspect ratio and MRR is insignificant.Keywords
Funding Information
- Intelligent Manufacturing “VR+” Online Education Technology Innovation Research Institute (JNSX2021050, ALK202108, YZKC202210)
- Construction of Case Library for the Course of Intelligent Manufacturing Technology Based on VR Technology (JNSX2021050, ALK202108, YZKC202210)
- High quality curriculum construction project of Shandong Jianzhu University graduate education (JNSX2021050, ALK202108, YZKC202210)
This publication has 19 references indexed in Scilit:
- Fabrication of High-Aspect-Ratio Structural Change Microregions in Silicon Carbide by Femtosecond Bessel BeamsAdvanced Materials Research, 2015
- Fabrication of through holes in silicon carbide using femtosecond laser irradiation and acid etchingApplied Surface Science, 2014
- Laser–material interaction and grooving performance in ultrafast laser ablation of crystalline germanium under ambient conditionsProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- High-aspect-ratio grooves fabricated in silicon by a single pass of femtosecond laser pulsesJournal of Applied Physics, 2012
- Experimental Study of the Effect of Pulsewidth on Ablation of Silicon Substrate Using Mega Hertz Repetition Rate Femtosecond LaserMaterials and Manufacturing Processes, 2011
- Femtosecond laser ablation of sapphire on different crystallographic facet planes by single and multiple laser pulses irradiationOptics and Lasers in Engineering, 2010
- Alcohol-assisted photoetching of silicon carbide with a femtosecond laserOptics Communications, 2009
- Enhancement of optical absorption and photocurrent of 6H-SiC by laser surface nanostructuringApplied Physics Letters, 2007
- Status of silicon carbide (SiC) as a wide-bandgap semiconductor for high-temperature applications: A reviewSolid-State Electronics, 1996
- Femtosecond, picosecond and nanosecond laser ablation of solidsApplied Physics A, 1996