The Effect of Wetting Gravity Regime on Shear Strength of SAC and Sn-Pb Solder Lap Joints
- 16 August 2017
- journal article
- research article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 26 (9) , 4177-4187
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Effect of Reflow Time on Wetting Behavior, Microstructure Evolution, and Joint Strength of Sn-2.5Ag-0.5Cu Solder on Bare and Nickel-Coated Copper SubstratesJournal of Electronic Materials, 2016
- Microstructural evolution and shear strength of AuSn20/Ni single lap solder jointsMicroelectronics Reliability, 2013
- Evaluation of Bulk Mechanical Properties of Selected Lead-Free Solders in Tension and in ShearJournal of Materials Engineering and Performance, 2013
- Reactive wetting, evolution of interfacial and bulk IMCs and their effect on mechanical properties of eutectic Sn–Cu solder alloyAdvances in Colloid and Interface Science, 2011
- Shear strength and interfacial microstructure of Sn–Ag–xNi/Cu single shear lap solder jointsMaterials Science and Engineering: A, 2007
- Novel rare-earth-containing lead-free solders with enhanced ductilityJOM, 2006
- Mechanical Properties for 95.5Sn–3.8Ag–0.7Cu Lead-Free Solder AlloyIEEE Transactions on Components and Packaging Technologies, 2005
- Effect of cooling rate on growth of the intermetallic compound and fracture mode of near-eutectic Sn-Ag-Cu/Cu pad: Before and after agingJournal of Electronic Materials, 2004
- Microscopic Experimental Investigation on Shear Failure of Solder JointsInternational Journal of Fracture, 2004
- The Thermal Contact Conductance of Hard and Soft Coat Anodized AluminumJournal of Heat Transfer, 1995