Application of the Taguchi Method for Optimizing the Process Parameters of Producing Controlled Low-Strength Materials by Using Dimension Stone Sludge and Lightweight Aggregates
Open Access
- 17 May 2021
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 13 (10) , 5576
Abstract
In view of the increasing concerns over non-renewable resource depletion and waste management, this paper studied the development of low-density controlled low-strength material (CLSM) by using stone sludge and lightweight aggregates. First, the investigation was performed at a laboratory scale to assess the effects of the composition on the properties of the resulting low-density CLSM. The Taguchi method with an L9(34) orthogonal array and four controllable three-level factors (i.e., the stone sludge dosage, water to binder ratio, accelerator dosage and lightweight aggregate dosage) was adopted. Then, to optimize the selected parameters, the analysis of variance method was used to explore the effects of the experimental factors on the performance (fresh and hardened properties) of the produced low-density CLSM. The test results show that when the percentage of stone sludge usage was increased from 30% to 60%, the initial setting time approximately doubled on average. Moreover, at the age of 28 days, the compressive strength of most specimens did not exceed the upper limit of 8.83 MPa stipulated by Taiwan’s Public Construction Commission. Further, the material cost per cubic meter of the produced CLSM was about NT$ 720.9 lower than that of the ordinary CLSM, which could reduce the cost by 40.6%. These results indicate that the use of stone sludge as a raw material to produce CLSM could achieve environmental sustainability. In other words, the use of stone sludge and lightweight aggregates to produce low-density CLSM was extremely feasible.Keywords
Funding Information
- the Ministry of Science and Technology of Taiwan (MOST 108-2622-E-230-003-CC3)
This publication has 29 references indexed in Scilit:
- Sustainable Development of Concrete through Aggregates and Innovative Materials: A ReviewApplied Sciences, 2021
- Evaluation of Mechanical Characteristics of Cement Mortar with Fine Recycled Concrete Aggregates (FRCA)Sustainability, 2021
- The Influence of Granite Cutting Waste on The Properties of Ultra-High Performance ConcreteMaterials, 2019
- Engineering Properties of Controlled Low-Strength Materials Containing Bottom Ash of Municipal Solid Waste Incinerator and Water Filter SiltApplied Sciences, 2018
- Properties of Controlled Low Strength Material with Circulating Fluidized Bed Combustion Ash and Recycled AggregatesMaterials, 2018
- Application of the Taguchi Method for Optimizing the Process Parameters of Producing Lightweight Aggregates by Incorporating Tile Grinding Sludge with Reservoir SedimentsMaterials, 2017
- Paper Sludge Reuse in Lightweight Aggregates ManufacturingMaterials, 2016
- Producing synthetic lightweight aggregates from reservoir sedimentsConstruction and Building Materials, 2012
- Potential use of stockpiled circulating fluidized bed combustion ashes in controlled low strength material (CLSM) mixtureConstruction and Building Materials, 2010
- Controlled low strength materials incorporating cement kiln dust from various sourcesCement and Concrete Composites, 2008