Process Challenges and Mitigation Techniques for Realization of RF Modules at Millimeter-wave Frequencies
- 24 October 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 7-12
Abstract
The critical aspect of circuit realization at higher frequencies poses various challenges as a small drift in phase or line parameters drastically affects circuit performances and the grounding effect becomes prominent at higher frequencies. Hence, attachment and proper field launching aspects becomes important. This article presents four innovative processes which have been developed for overcoming these challenges for timely realisation of a reliable millimeter wave Data Transmitter: attachment of thin Printed Circuit Boards (PCBs) to carrier plates using epoxy film to avoid bowing issues and enhance proper electrical grounding, pattern generation with 40 μm feature size in 45 o phase shifter, trimming of microstrip length to achieve required phase-shift angle and assembly of state-of-the-art Radio-Frequency (RF) connector pins. Data Transmitter at high frequency thus realised was flown onboard and performance is satisfactory. In this article, the various new processes developed to enable reliable performance of the circuits at higher frequencies are presented. Also, it addresses the challenges as well as the mitigation techniques. The results are also presented.Keywords
This publication has 15 references indexed in Scilit:
- QFN reliability, thermal shock, lead-free vs. SnPb, microstructure2017
- Resistor trimming geometry; past, present and futureIOP Conference Series: Materials Science and Engineering, 2016
- Microwave integrated circuits fabrication on alumina substrate using pattern up direct electroless nickel and immersion Au plating and study of its propertiesMicroelectronic Engineering, 2013
- Aspects of applying flip-chip technology for SiC power devices assembly2013
- Laser Trimming of CuAlMo Thin-Film Resistors: Effect of Laser Processing ParametersJournal of Electronic Materials, 2012
- Low cost QFN package design for millimeter-wave applications2012
- A Ka-band transceiver front-end module for wide band wireless communication2011
- A compact LTCC Transmit Receive module at Ku-band2010
- Study on the Board-level SMT Assembly and Solder Joint Reliability of Different QFN Packages2007
- Low-Cost Ka-Band Transmitter for VSAT Applications2006