Multifaceted Impact of Lipid Extraction on the Characteristics of Polymer-Based Sewage Sludge towards Sustainable Sludge Management
Authors:
- Nor Afifah KhalilNor Afifah Khalil
- Ahmad Fiqhri LajulliadiALAhmad Fiqhri Lajulliadi
- Fatin Najwa Joynal AbedinFatin Najwa Joynal Abedin
- Ahmad Noor Syimir FizalAFAhmad Noor Syimir Fizal
- Sairul Izwan SafieSSSairul Izwan Safie
- Muzafar ZulkifliMuzafar Zulkifli
- Wirach TaweepredaWirach Taweepreda
- Sohrab HossainSohrab Hossain
- Ahmad Naim Ahmad YahayaAYAhmad Naim Ahmad Yahaya
Open Access
- 19 September 2024
- Vol. 16 (18) , 2646
Abstract
Dewatered sludge (DS) is a sewage sludge with a unique property due to extracellular polymeric substances (EPSs) and polymer flocculants. These components form a stable 3D polymer network to increase dewatering efficiency, leaving behind valuable materials such as lipids. This article explored the influences of DS particle size on lipid yield and the effects of extraction on the chemical, morphological, and thermal properties of the residual dewatered sludge (RDS). Lipid yields with unimodal distribution were observed across the particle size ranges (<0.5, 0.5–1.0, 1.0–2.0, 2.0–4.0, and 4.0 mm). The highest lipid yield of 1.95% was extracted from 1.0–2.0 mm after 4 h at 70 °C and 0.1 g/mL sludge-to-solvent ratio. Efficiency was influenced by the DS’s morphology, facilitating solvent infiltration and pore diffusion. The extraction process reduced water and organic fractions, resulting in higher thermal stability. Bibliometric analysis of “extraction*” and “sewage sludge” shows increasing research interest from 1973 to 2024. Five research clusters were observed: heavy metal speciation and stabilization, sludge and its bioavailability, extraction techniques and resource recovery, contaminants remediation, as well as phosphorus recovery and agricultural applications. These clusters highlight the diverse approaches to researching DS and RDS while promoting sustainable waste management.Keywords
Funding Information
- Faculty of Science, Prince of Songkhla University (UniKL/CoRI/UER20016)
- Universiti Kuala Lumpur (UniKL/CoRI/UER20016)
This publication has 119 references indexed in Scilit:
- Research on a new cationic polyacrylamide (CPAM) with a cationic microblock structure and its enhanced effect on sludge condition and dewateringEnvironmental Science and Pollution Research, 2021
- Qualitative analysis of activated sludge using FT-IR techniqueChemical Papers, 2018
- Past, current, and future research on microalga-derived biodiesel: a critical review and bibliometric analysisEnvironmental Science and Pollution Research, 2018
- Lead and Zinc Stabilization of Soil Using Sewage Sludge Biochar: Optimization through Response Surface MethodologyCLEAN – Soil, Air, Water, 2018
- pH‐sensitive polymeric particles as smart carriers for rebar inhibitors delivery in alkaline conditionJournal of Applied Polymer Science, 2017
- Preparation of modified waterworks sludge particles as adsorbent to enhance coagulation of slightly polluted source waterEnvironmental Science and Pollution Research, 2017
- Structural Aspects and Thermal Degradation Kinetics of Water Treatment Plant Sludge of Moroccan CapitalWaste and Biomass Valorization, 2016
- Change of thermal drying characteristics for dewatered sewage sludge based on anaerobic digestionJournal of Thermal Analysis and Calorimetry, 2012
- Extraction of Lipids from Municipal Wastewater Plant Microorganisms for Production of BiodieselJournal of the American Oil Chemists' Society, 2007
- Solvent extraction. III. The effect of particle size on extraction rateJournal of the American Oil Chemists' Society, 1950