Model and Characterization of a Press-Button-Type Piezoelectric Energy Harvester
- 15 October 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 24 (1) , 132-143
Abstract
In this paper, a press-button type piezoelectric energy harvester (PEH) is presented. The proposed device is composed of a piezoelectric bender, four magnets, a button, and a reverted spring. The proposed structure is triggered by an impact driven by magnetic force, so this novel trigger mechanism enhances its optimal power output. Based on the piezoelectricity, beam theory and the vibration theory, a complete numerical model was developed to simulate and predict the output voltage. A prototype was fabricated for verification, and the characterization of the energy harvester was measured. The harvested power and energy by a single impact was recorded as 20 mW and 190 μJ, respectively, at an optimum resistive load of 30 kΩ. The measured data agreed with the results of numerical model. Finally, the piezoelectric energy charger extractor (PECE) was used to store the harvested energy. The energy stored in a capacitor of 1 μF was 42.1 μJ.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST 104-2220-E-006-002)
This publication has 29 references indexed in Scilit:
- Modeling and experimental investigation of an impact-driven piezoelectric energy harvester from human motionSmart Materials and Structures, 2013
- Plucked piezoelectric bimorphs for knee-joint energy harvesting: modelling and experimental validationSmart Materials and Structures, 2011
- Broadband vibration-based energy harvesting improvement through frequency up-conversion by magnetic excitationSmart Materials and Structures, 2010
- Powering MEMS portable devices—a review of non-regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting systemsSmart Materials and Structures, 2008
- A review of power harvesting using piezoelectric materials (2003–2006)Smart Materials and Structures, 2007
- Resonance tuning of piezoelectric vibration energy scavenging generators using compressive axial preloadSmart Materials and Structures, 2006
- Energy Scavenging for Mobile and Wireless ElectronicsIEEE Pervasive Computing, 2005
- Energy Harvesting Using a Piezoelectric “Cymbal” Transducer in Dynamic EnvironmentJapanese Journal of Applied Physics, 2004
- A piezoelectric vibration based generator for wireless electronicsSmart Materials and Structures, 2004
- Energy scavenging with shoe-mounted piezoelectricsIEEE Micro, 2001