We report the latest developments of MW HgCdTe electron initiated avalanche photo-diodes (e-APDs) focal plane arrays (FPAs) at CEA-LETI. The MW e-APD FPAs are developed in view of ultra-sensitive high dynamic range passive starring arrays, active 2D/3D and dual-mode passive-active imaging, which is why both the passive imaging performance and the gain characteristics of the APDs are of interest. A passive mode responsivity operability of 99.9% was measured in LPE and MBE e-APDs FPAs associated with an average NETD=12mK, demonstrating that dual mode passive-active imaging can be achieved with LETI e-APDs without degradation in the passive imaging performance. The gain and sensitivity performances were measured in test arrays and using a low voltage technology (3.3V) CTIA test pixel designed for 3D active imaging. The CTIA and test arrays measurements yielded comparable results in terms of bias gain dependence (M=100 at Vb=-7V), low excess noise factor (=1.2) and low equivalent input current (Ieq_in100, associated with an operability of 99%. The operability at Ieq_inM=30 was 95%. A record low value of Ieq_in=1fA was estimated in the MBE e-APDs at M=100, indicating the potential for using the MW e-APDs for very low flux applications. The high potential of the MW e-APDS for active imaging was demonstrated by impulse response measurements which yielded a typical rise time lower than 100ps and diffusion limited fall time of 900ps to 5ns, depending on the pixel pitch. This potential was confirmed by the demonstration of a 2ns time of flight (TOF) resolution in the CTIA e-APD 3D pixel. The combined photon and dark current induced equivalent back ground noise at f/8 with a cold band pass filter at λ=1.55μm was 2 electrons rms for an integration time of 50ns.