Numerical simulation and experimental investigation on jetting phenomenon in low pressure injection molding (LPIM) of alumina
Authors:
- M. SardarianMSM. Sardarian
- O. MirzaeeOMO. Mirzaee
- A. HabibolahzadehAHA. Habibolahzadeh
- 1 May 2017
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 243, 374-380
Abstract
No abstract availableThis publication has 12 references indexed in Scilit:
- Partial wick-debinding of low-pressure powder injection-moulded ceramic partsJournal of the European Ceramic Society, 2010
- Effect of powders and binders on material properties and molding parameters in iron and stainless steel powder injection molding processPowder Technology, 2009
- Direct observation of mould cavity filling in ceramic injection mouldingJournal of the European Ceramic Society, 2008
- The effect of constitutive description of PIM feedstock viscosity in numerical analysis of the powder injection moulding processJournal of Materials Processing Technology, 2006
- Analysis of the rheological behavior and stability of 316L stainless steel–TiC powder injection molding feedstockMaterials Science and Engineering: A, 2005
- Jetting in metal injection moulding of 316L stainless steelPowder Metallurgy, 2005
- Rheological properties of alumina injection feedstocksMaterials Research, 2005
- Effect of Surface‐Active Substances on the Rheological Properties of Silicon Carbide Suspensions in ParaffinJournal of the American Ceramic Society, 2000
- Rheology of injection-molded zirconia-wax mixturesJournal of Materials Science, 2000
- Jetting and weld lines in ceramic injection mouldingBritish Ceramic Transactions, 1999