Experimental Analysis of Unequal Voltage Distribution on a Single YBCO Coated Conductor Affected by Inhomogeneous Critical Currents in Liquid Nitrogen and Sub-Cooled Liquid Nitrogen
- 17 December 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 21 (3) , 2992-2996
Abstract
To design a large scale superconducting fault current limiter (SFCL) for power grids, a single long-length YBCO coated conductor (CC) wire is preferred. However this single YBCO CC wire can cause a problem of unequal voltage distribution between the parts on the long wire at quench by the faults. Inhomogeneous critical current of the YBCO CCs in the SFCL is a possibility. Furthermore, sub-cooled liquid nitrogen (LN2) condition is usually used to increase current capacity of the SFCL. However, this sub-cooled condition can worsen the inhomogeneity between the YBCO CCs. Therefore, it is important to understand the relation between the unequal voltage distribution and the inhomogeneous critical currents in the single long length YBCO CC. In this paper, experiments with the same single YBCO CC wire were conducted in various temperature conditions, LN2 and sub-cooled LN2 . In both experiments, the critical currents and voltage distributions generated by faults at short-circuit tests were measured. It was observed that the inhomogeneous condition impacts on the unequal voltage distribution.Keywords
This publication has 7 references indexed in Scilit:
- Parameter Determination of a Condition for Simultaneous Quench in Series-Connected YBCO Coated ConductorsIEEE Transactions on Applied Superconductivity, 2010
- Characteristics of Simultaneous Quenches in Series-Connected YBaCuO Coated ConductorsIEEE Transactions on Applied Superconductivity, 2009
- Investigation of YBCO Coated Conductors for Fault Current Limiter ApplicationsIEEE Transactions on Applied Superconductivity, 2007
- Investigation of YBCO Coated Conductor for Application in Resistive Superconducting Fault Current LimitersIEEE Transactions on Applied Superconductivity, 2007
- Manufacture and Test of the Bifilar Wound Coil Using Coated Conductor With Stainless Steel StabilizerIEEE Transactions on Applied Superconductivity, 2007
- Test Results of a Superconducting Fault Current Limiter Using YBCO Coated ConductorIEEE Transactions on Applied Superconductivity, 2007
- High-Tc superconducting materials for electric power applicationsNature, 2001