Influence of laser parameters on texturing of 3Y‐TZP and Ce‐TZP/Al 2 O 3 /SrAl 12 O 19 composite
- 16 February 2025
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 108 (6)
Abstract
The development of new materials and surface functionalization processes has been extensively studied to further improve the performance of implants. This work explores the direct laser writing method as a potential alternative to produce controlled textures on the surface of traditional 3Y‐TZP and a novel high‐toughness composite (Ce‐TZP/Al 2 O 3 /SrAl 12 O 19 ). A 532 nm picosecond laser source is used to produce lines in sintered samples of both materials with different values of laser fluence, repetition rate, and scanning speed. The resulting textured samples are analyzed using confocal and scanning electron microscopes. Both materials were successfully textured using the laser technique, but the groove morphology and geometry are highly dependent on the parameters used. While low energy results in shallow and irregular grooves, high energy can result in crack and resolidification layer. Overall, for the same set of parameters, the laser produced wider and deeper grooves in the nanocomposite (up to 30 µm wide and 26 µm deep) than in the 3Y‐TZP (up to 12 µm wide and 6 µm deep). Hence, this work showed the feasibility of laser texturing of traditional 3Y‐TZP and the novel Ce‐TZP/Al 2 O 3 /SrAl 12 O 19 that can be further explored to functionalize their surfaces for biomedical applications.Keywords
This publication has 33 references indexed in Scilit:
- Influence of ns-Nd:YAG laser surface treatment on the tensile bond strength of zirconia to resin-matrix cementsCeramics International, 2020
- Ultrashort-pulse laser as a surface treatment for bonding between zirconia and resin cementDental Materials, 2019
- The Role of Defects in Pulsed Laser Matter Interaction2018
- Towards long lasting zirconia-based composites for dental implants: Transformation induced plasticity and its consequence on ceramic reliabilityActa Biomaterialia, 2017
- Review of zirconia-based bioceramic: Surface modification and cellular responseCeramics International, 2016
- Multiscale grooved titanium processed with femtosecond laser influences mesenchymal stem cell morphology, adhesion, and matrix organizationJournal of Biomedical Materials Research Part A, 2012
- Femtosecond laser microstructuring of zirconia dental implantsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2010
- Low temperature degradation -aging- of zirconia: A critical review of the relevant aspects in dentistryDental Materials, 2010
- Laser machining of structural ceramics—A reviewJournal of the European Ceramic Society, 2009
- Thermal conductivity of zirconia–alumina compositesCeramics International, 2005