Abstract
The development of electrochemical discharge machining (ECDM) and the use of electrically nonconducting materials in microelectromechanical systems (MEMS), biomedical applications and making lab-on-a-chip devices are increasing tremendously. In this study, the performance of electrochemical discharge milling was improved by introducing the bottom-up movement of tool-electrode, i.e. vertically upward tool-feeding technique. The development of gas film model was compared with the actual gas film shapes to find out the problems associated with the existing tool-feeding technique and the advantages of vertically upward tool-feeding technique. Single channels were generated on the soda lime glass workpiece to analyze and obtain appropriate process parameters for good-quality channels. Applied voltage, electrolyte concentration and tool feed rate (TFR) were varied to get good-quality channel. It was achieved at the process parameters of an applied voltage of 40 V, an electrolyte concentration of 5 M and a TFR of 50 [ ]m/s. With this parametric setting, four consecutive parallel channels were generated to get cavity on the soda lime glass. Rectangular-shaped cavities were fabricated by adopting three different strategies to minimize the problem of material deposition along the border of two adjacent parallel channels. These rectangular cavities were observed under a microscope to measure and obtain the surface topography which revealed the usability of third strategy of generating smooth and uniform cavity with lower surface roughness ([ ][ ]). A rectangular cavity of 0.247-[ ]m surface roughness with smooth corners and edges was obtained at 40 V of applied voltage and 50 [ ]m/s of TFR.

This publication has 26 references indexed in Scilit: