Influence of inlet pressure and geometric variations on the applicability of Eductor in low temperature thermal desalinations
Open Access
- 16 April 2021
- journal article
- research article
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 35 (2) , 137-147
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- Review of membrane distillation process for water purificationDesalination and Water Treatment, 2016
- Status of membrane distillation for water and wastewater treatment—A reviewDesalination and Water Treatment, 2014
- Experimental and numerical investigation of the effect of mixing section length on direct-contact condensation in steam jet pumpInternational Journal of Heat and Mass Transfer, 2014
- Experimental comparison of direct contact membrane distillation (DCMD) with vacuum membrane distillation (VMD)Desalination and Water Treatment, 2013
- Modeling and experimental investigation on water-driven steam injector for waste heat recoveryApplied Thermal Engineering, 2012
- Effect of primary jet geometry on ejector performance: A cold-flow investigationInternational Journal of Heat and Fluid Flow, 2011
- HYDRAULIC PUMPING2008
- Desalination by vacuum membrane distillation: sensitivity analysisSeparation and Purification Technology, 2003
- Parallelism and differences of pervaporation and vacuum membrane distillation in the removal of VOCs from aqueous streamsSeparation and Purification Technology, 2001
- Membrane distillation for dilute ethanolJournal of Membrane Science, 1999