Quoc Linh Ve
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Quoc Linh Ve has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Hosam Faqeha
6 shared publicationsMohammed Bawahab
6 shared publicationsAbhijit Date
5 shared publicationsAliakbar Akbarzadeh
Mechanical and Automotive Engineering, School of Engineering, RMIT University, VIC 3083, Australia
4 shared publications- Abhijit Date
School of Engineering, RMIT University, Melbourne, VIC 3000, Australia
3 shared publications - Ahmadreza Faghih Khorasani
Department of Mechanical Engineering, Yazd University, Yazd, Iran
3 shared publications
Latest Publications
- Open Access
- 1 October 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 26 (10) , 218-230
Evaluation of thermal decomposition and ash transformation of water hyacinth pellets for sustainable bioenergy
Water hyacinth (Eichhornia crassipes), an invasive aquatic plant with exceptionally high yield, is increasingly considered a renewable energy feedstock. This study examines its thermal decomposition and ash evolution between 600 and 900 °C using thermogravimetric analysis (TG/DTG), scanning...
- 1 October 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 26 (10) , 218-230
Open AccessEvaluation of thermal decomposition and ash transformation of water hyacinth pellets for sustainable bioenergy
Water hyacinth (Eichhornia crassipes), an invasive aquatic plant with exceptionally high yield, is increasingly considered a renewable energy feedstock. This study examines its thermal decomposition and ash evolution between 600 and 900 °C using thermogravimetric analysis (TG/DTG), scanning...
- Open Access
- 23 June 2024
- Published by Discovery Scientific Society in Indian Journal of Engineering
- Vol. 21 (55) , 1-18
Thin film theory and boundary layer theory, an approach for analysing heat and mass transfer in spacer-filled Direct Contact Membrane Distillation
- 23 June 2024
- Published by Discovery Scientific Society in Indian Journal of Engineering
- Vol. 21 (55) , 1-18
Open AccessThin film theory and boundary layer theory, an approach for analysing heat and mass transfer in spacer-filled Direct Contact Membrane Distillation
- Open Access
- 31 October 2022
- Published by Journal of Experimental Biology and Agricultural Sciences in Journal of Experimental Biology and Agricultural Sciences
- Vol. 10 (5) , 1024-1032
Physicochemical and Biological Characteristics of Shrimp Pond Sludge in the Thua Thien Hue Province, Vietnam
This study has been carried out to analyze the physical and biological indicators of shrimp pond sludge samples obtained from the Phu Vang and Phu Loc districts of the Thua Thien Hue Province, Vietnam. All standard methodologies have been used to analyze the selected parameters like pH, organic carbon, total nitrogen, total phosphate, and microbial density. The results of the study revealed that the sludge was characterized by a neutral to alkaline pH (6.9 - 7.5), and the total organic carbon content was in the range of 103.8–173.5 mg/kg. The sludge was rich in organic matter (17.8–29.9%), total nitrogen (13.5–32.5 g/kg), and total phosphate (7.9-20.1 g/kg). Further, in the case of the microbial density of pathogenic microorganisms, the density of total bacteria, coliform, E.coli, Salmonella spp., Vibrio spp., and Clostridium spp. was also estimated at two opposing weather conditions (spring, February to March; summer, June to July). The microbial community increased rapidly during the cool spring months. The total bacterial levels were recorded as 8.77 log10 CFU/mL in the Phu Loc district and 9.11 log10 CFU/mL in the Phu Vang district. The levels decreased during the hot summer months, and the level of total bacteria, Coliform, E.coli, Salmonella spp., and Vibrio was reported 2.57, 1.49, 1.06, 0.56, and l2.54 log10 CFU/mL respectively from the Phu Loc district of Vietnam. The results obtained using the anaerobic decomposition model showed that on the 60th day, the amount of CH4 generated at the high output value for the Phu Vang district was 22385 ppm. The results reported here revealed that CH4 gas can be potentially produced from shrimp waste sludge in this province.
- 31 October 2022
- Published by Journal of Experimental Biology and Agricultural Sciences in Journal of Experimental Biology and Agricultural Sciences
- Vol. 10 (5) , 1024-1032
Open AccessPhysicochemical and Biological Characteristics of Shrimp Pond Sludge in the Thua Thien Hue Province, Vietnam
This study has been carried out to analyze the physical and biological indicators of shrimp pond sludge samples obtained from the Phu Vang and Phu Loc districts of the Thua Thien Hue Province, Vietnam. All standard methodologies have been used to analyze the selected parameters like pH, organic carbon, total nitrogen, total phosphate, and microbial density. The results of the study revealed that the sludge was characterized by a neutral to alkaline pH (6.9 - 7.5), and the total organic carbon content was in the range of 103.8–173.5 mg/kg. The sludge was rich in organic matter (17.8–29.9%), total nitrogen (13.5–32.5 g/kg), and total phosphate (7.9-20.1 g/kg). Further, in the case of the microbial density of pathogenic microorganisms, the density of total bacteria, coliform, E.coli, Salmonella spp., Vibrio spp., and Clostridium spp. was also estimated at two opposing weather conditions (spring, February to March; summer, June to July). The microbial community increased rapidly during the cool spring months. The total bacterial levels were recorded as 8.77 log10 CFU/mL in the Phu Loc district and 9.11 log10 CFU/mL in the Phu Vang district. The levels decreased during the hot summer months, and the level of total bacteria, Coliform, E.coli, Salmonella spp., and Vibrio was reported 2.57, 1.49, 1.06, 0.56, and l2.54 log10 CFU/mL respectively from the Phu Loc district of Vietnam. The results obtained using the anaerobic decomposition model showed that on the 60th day, the amount of CH4 generated at the high output value for the Phu Vang district was 22385 ppm. The results reported here revealed that CH4 gas can be potentially produced from shrimp waste sludge in this province.
- Open Access
A Review on Process and Practices in Operation and Design Modification of Ejectors
This work reviews the current operational condition and activities on design modification for different applications of ejectors. Ejectors being a simple mechanical system capable of performing multiple fluid related functions (vacuum generation, pumping, mixing, condensing and heat exchanging), have been an essential part of several industrial processes. Two areas have been emphasized; internal flow and application-based modifications in components of ejectors. The geometry and inlet flow conditions were found to be the prime influencing factor of its performance. The objective and application-based modifications were performed on the primary nozzle, secondary nozzle, mixing chamber, throat and diffuser. The resultant performance was found to be dependent on operational condition and fluid type. This emphasizes the requirement of application-based design selection of the technology. In addition, the flow dynamics of condensing, non-condensing, particle and slurry flow has been studied based on available literatures. The one-point final objective is to identify the usability of primary water jet ejectors for active vapor transport and condensation, to replace vacuum pump and condenser in compact domestic water desalination system.
Open AccessA Review on Process and Practices in Operation and Design Modification of Ejectors
This work reviews the current operational condition and activities on design modification for different applications of ejectors. Ejectors being a simple mechanical system capable of performing multiple fluid related functions (vacuum generation, pumping, mixing, condensing and heat exchanging), have been an essential part of several industrial processes. Two areas have been emphasized; internal flow and application-based modifications in components of ejectors. The geometry and inlet flow conditions were found to be the prime influencing factor of its performance. The objective and application-based modifications were performed on the primary nozzle, secondary nozzle, mixing chamber, throat and diffuser. The resultant performance was found to be dependent on operational condition and fluid type. This emphasizes the requirement of application-based design selection of the technology. In addition, the flow dynamics of condensing, non-condensing, particle and slurry flow has been studied based on available literatures. The one-point final objective is to identify the usability of primary water jet ejectors for active vapor transport and condensation, to replace vacuum pump and condenser in compact domestic water desalination system.
- Open Access
- 16 April 2021
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 35 (2) , 137-147
Influence of inlet pressure and geometric variations on the applicability of Eductor in low temperature thermal desalinations
- 16 April 2021
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 35 (2) , 137-147
Open AccessInfluence of inlet pressure and geometric variations on the applicability of Eductor in low temperature thermal desalinations
- 30 October 2019
- Published by Wiley in Journal of Heat Transfer
- Vol. 142 (1)
Experimental Investigation of Heat Transfer Correlation for Direct Contact Membrane Distillation
This paper presents an experimental investigation of heat transfer in direct contact membrane distillation (DCMD) flow channels with and without the spacer. In this experiment, the usual hydrophobic membrane of DCMD is replaced by a copper plate to eliminate mass transfer. The study shows the most appropriate heat transfer correlations for empty channel cases with different channel heights and flow rates. For the case with the spacer in the flow channels, two spacer materials are investigated: nonwoven plastic and woven stainless steel. The paper presents the most appropriate heat transfer correlation for both these spacer materials. Further, the paper presents finding with two more spacer materials, woven fiberglass and aluminum spacer. It is found that the most appropriate heat transfer correlation for these materials is in the turbulent flow regime although the experimentally estimated Reynolds number suggests laminar flow is presented.
- 30 October 2019
- Published by Wiley in Journal of Heat Transfer
- Vol. 142 (1)
Experimental Investigation of Heat Transfer Correlation for Direct Contact Membrane Distillation
This paper presents an experimental investigation of heat transfer in direct contact membrane distillation (DCMD) flow channels with and without the spacer. In this experiment, the usual hydrophobic membrane of DCMD is replaced by a copper plate to eliminate mass transfer. The study shows the most appropriate heat transfer correlations for empty channel cases with different channel heights and flow rates. For the case with the spacer in the flow channels, two spacer materials are investigated: nonwoven plastic and woven stainless steel. The paper presents the most appropriate heat transfer correlation for both these spacer materials. Further, the paper presents finding with two more spacer materials, woven fiberglass and aluminum spacer. It is found that the most appropriate heat transfer correlation for these materials is in the turbulent flow regime although the experimentally estimated Reynolds number suggests laminar flow is presented.
- Open Access
- 1 February 2019
- Published by Elsevier in Energy Procedia
- Vol. 160, 223-230
An experimental heat transfer investigation of using spacer in direct contact membrane distillation
- 1 February 2019
- Published by Elsevier in Energy Procedia
- Vol. 160, 223-230
Open AccessAn experimental heat transfer investigation of using spacer in direct contact membrane distillation
- Open Access
- 1 February 2019
- Published by Elsevier in Energy Procedia
- Vol. 160, 239-245
An experimental study to establish a salt gradient solar pond (SGSP)
- 1 February 2019
- Published by Elsevier in Energy Procedia
- Vol. 160, 239-245
Open AccessAn experimental study to establish a salt gradient solar pond (SGSP)