Effect of process parameters on grain morphology and high-temperature mechanical properties of Inconel 718 manufactured by EB-PBF
Authors:
- Hasina Tabassum ChowdhuryHCHasina Tabassum Chowdhury
- Aoi MorishigeAMAoi Morishige
- Thaviti Naidu PalledaTPThaviti Naidu Palleda
- Naoto KakutaNKNaoto Kakuta
- Koji KakehiKKKoji Kakehi
- Ayumu MiyakitaAMAyumu Miyakita
Open Access
- 10 March 2025
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 931
Abstract
No abstract availableFunding Information
- Japan Society for the Promotion of Science (22H01366)
This publication has 29 references indexed in Scilit:
- Correlation of Microstructure to Creep Response of Hot Isostatically Pressed and Aged Electron Beam Melted Inconel 718Metallurgical and Materials Transactions A, 2018
- Single-Track Melt-Pool Measurements and Microstructures in Inconel 625JOM, 2018
- Localized melt-scan strategy for site specific control of grain size and primary dendrite arm spacing in electron beam additive manufacturingActa Materialia, 2017
- A Comprehensive Comparison of the Analytical and Numerical Prediction of the Thermal History and Solidification Microstructure of Inconel 718 Products Made by Laser Powder-Bed FusionEngineering, 2017
- Microstructure and yield strength of SLM-fabricated CM247LC Ni-SuperalloyActa Materialia, 2017
- Numerical modeling of heat-transfer and the influence of process parameters on tailoring the grain morphology of IN718 in electron beam additive manufacturingActa Materialia, 2016
- Unexpected δ-Phase Formation in Additive-Manufactured Ni-Based SuperalloyJOM, 2016
- Prediction and characterization of variant electron diffraction patterns for γ″ and δ precipitates in an INCONEL 718 alloyMetallurgical and Materials Transactions A, 1999
- Primary spacing selection of constrained dendritic growthJournal of Crystal Growth, 1993
- Dendrite growth at the limit of stability: tip radius and spacingActa Metallurgica, 1981