A CFD Comparative Study of Bubbling Fluidized Bed Behavior with Thermal Effects Using the Open-Source Platforms MFiX and OpenFOAM
Open Access
Abstract
This work studies the performance of two open-source CFD codes, OpenFOAM and MFiX, to address bubbling fluidized bed system at different temperature and heat transfer conditions. Both codes are used to predict two parameters that are relevant for the design of fluidized units: the minimum fluidization velocity as a function of the temperature of the bed and wall-to-bed heat transfer coefficient from a lateral wall and from internal tubes. Although the CFD solvers are structuraly similar, there are some key differences (available models, meshing techniques, and balance formulations) that are often translated into differences in the fields prediction. The computational results are compared between both codes and against the experimental data. The minimum fluidization velocity can be correctly predicted with both codes at different temperatures while, in general, for the heat transfer and the fluidization patterns, MFiX shows slightly more accurate results compared to OpenFOAM but with low versatility for meshing curved geometries which might translate into higher computational costs for the same level of accuracy.Keywords
Funding Information
- Agencia Nacional de Promoción Científica y Tecnológica (PICT 2019-01810, PICT 2016-2908)
- Consejo Nacional de Investigaciones Científicas y Técnicas (PUE PROBIEN 22920150100067)
- Universidad Nacional de San Juan (PDTS Res. 1054/18)
This publication has 32 references indexed in Scilit:
- Computational fluid dynamics simulations of heat transfer between the dense‐phase of a high‐temperature fluidized bed and an immersed surfaceAIChE Journal, 2011
- Heat transfer and bubble characteristics in a fluidized bed with immersed horizontal tube bundleInternational Journal of Heat and Mass Transfer, 2003
- EVALUATION OF OVERALL HEAT TRANSFER RATES BETWEEN BUBBLING FLUIDIZED BEDS AND IMMERSED SURFACESChemical Engineering Communications, 1997
- EVALUATION OF CONDUCTIVE HEAT TRANSFER MECHANISMS BETWEEN AN IMMERSED SURFACE AND THE ADJACENT LAYER OF PARTICLES IN BUBBLING FLUIDIZED BEDSChemical Engineering Communications, 1997
- Numerical calculation of wall‐to‐bed heat‐transfer coefficients in gas‐fluidized bedsAIChE Journal, 1992
- Effect of operating temperature on minimum fluidization velocityPowder Technology, 1991
- Instability in the evolution equations describing incompressible granular flowJournal of Differential Equations, 1987
- Transfer of heat or mass to particles in fixed and fluidised bedsInternational Journal of Heat and Mass Transfer, 1978
- Types of gas fluidizationPowder Technology, 1973
- A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flowsInternational Journal of Heat and Mass Transfer, 1972