Component‐section transverse‐pressure effect on internal damage and failure mode of post‐installed rebar
Authors:
- 12 November 2024
- journal article
- research article
- Published by Wiley in Structural Concrete
- Vol. 26 (3) , 3565-3581
Abstract
A post‐installed rebar (PIR) is commonly used to establish structural connections between new components and existing structures, such as structural member extensions or concrete layer overlays in the construction/strengthening/retrofitting of buildings or bridges. In joint connections, the anchored PIR system always bears a non‐negligible compression in the component section, which is derived from the loads and self‐weight and has a confinement effect on the anchorage zone. However, excessive pressure can result in the fracture of the adhesive component, thereby leading to brittle failure in the PIR system. Owing to the important role of the adhesive component in the PIR system, this study is focused on the internal damage to the PIR system, and the effect of transverse pressure on the failure modes is investigated. This study comprises an experimental investigation of the failures of a PIR system under transverse pressure and a description of the internal damages based on the test results. Finally, an elastic analysis was established to explain the internal cracking and investigate the stress distribution in the PIR system. The tests on 34 pull‐out specimens showed two typical failures for the PIR system under transverse pressure (adhesive–rebar [A–R] interface failure and adhesive fracture failure). The A–R interface failure resulted from the shearing failure in the adhesive component, while the adhesive fracture failure resulted from the propagation of longitudinal and transverse cracks. The elastic analysis indicated that cracking in the concrete and adhesive component was dominated by circumferential stress, and the rebar rib direction and adhesive component thickness had a significant influence on the stress distribution. Based on this, some suggestions for anchorage design were made.Keywords
Funding Information
- Chongqing Municipal Construction Science and Technology Plan Project (CKZ2024‐03‐05)
This publication has 21 references indexed in Scilit:
- Assessment of bond behavior in fly ash cenosphere concrete using plain and deformed rebarsStructural Concrete, 2024
- Investigation on bond in post‐installed anchored bars and lap splices subjected to direct tensionStructural Concrete, 2023
- Cast-in and post-installed rebar anchorage systems in RC column foundation joints: System specific assessment and designEngineering Structures, 2022
- Re-evaluation of existing tests on RC connections using post-installed reinforcing barsEngineering Structures, 2020
- Role of Internal Damage Mechanisms in Controlling Bond-Slip Behavior in Pullout Tests in ConcreteJournal of Materials in Civil Engineering, 2019
- Structural behaviour of post-installed reinforcement bars in moment connections of wall-slabsEngineering Structures, 2019
- Post‐installed reinforcement connections at ultimate and serviceability limit statesStructural Concrete, 2014
- Experimental Study on the Bond Behavior of Reinforcing Bars Embedded in Concrete Subjected to Lateral PressureJournal of Materials in Civil Engineering, 2012
- Behavior of Chemically Bonded AnchorsJournal of Structural Engineering, 1993
- Cracks Formed in Concrete Around Deformed Tension BarsACI Journal Proceedings, 1971