Design of Direct 48-V/1-V Three-Path Four-State Switching Power Converter With Adaptive VCF Rebalancing and Dual-Edge tdead Modulation
- 18 September 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (5) , 1592-1602
Abstract
This article presents a new power converter capable of direct 48-V/1-V dc–dc conversion with high efficiency. The proposed three-path four-state (3P4S) hybrid switching power stage enables high switching frequency ( $f_{\mathrm {SW}}$ ) operation and minimizes power passives by significantly reducing power switch voltage stress. To address the issues of power delivery path imbalances and potential device breakdown, an adaptive flying capacitor voltage ( $V_{\mathrm {CF}}$ ) rebalancing technique is introduced that improves design robustness and eliminates the need for direct floating $V_{\mathrm {CF}}$ sensing. Additionally, a dual-edge deadtime ( $t_{\mathrm {dead}}$ ) modulation with elastic $t_{\mathrm {dead}}$ control at switching nodes optimizes converter efficiency across different input voltage and load conditions. An IC prototype of the design was fabricated and tested with input voltage $V_{\mathrm {IN}}$ ranging from 12 to 48 V, delivering up to 4 W of power at 1-V $V_{\mathrm {O}}$ . It achieves peak efficiency of 90.7% and 85.6% for 12-V/1-V and 48-V/1-V power conversion, respectively, at an effective switching frequency of 4.5 MHz, which is based on a three-phase operation with each phase at 1.5 MHz. The adaptive $V_{\mathrm {CF}}$ rebalancing technique reduces $V_{\mathrm {CF}}$ imbalance error by up to 65.1%. Overall, the proposed 3P4S hybrid switching power converter offers an efficient and robust solution for direct dc–dc conversion with a wide $V_{\mathrm {IN}}$ range.Keywords
Funding Information
- Texas Instruments
This publication has 13 references indexed in Scilit:
- A 90.4% Peak Efficiency 48-to-1-V GaN/Si Hybrid Converter With Three-Level Hybrid Dickson Topology and Gradient Descent Run-Time OptimizerIEEE Journal of Solid-State Circuits, 2022
- A Monolithic GaN Power IC With On-Chip Gate Driving, Level Shifting, and Temperature Sensing, Achieving Direct 48-V/1-V DC–DC ConversionIEEE Journal of Solid-State Circuits, 2022
- Direct 12V/24V-to-1V Tri-State Double Step-Down Power Converter With Online V CF Rebalancing and In-Situ Precharge Rate RegulationIEEE Journal of Solid-State Circuits, 2021
- Comparative Topology and Power Loss Analysis on 48V-to-1V Direct Step-Down Non-Isolated DC-DC Switched-Mode Power Converters2020
- A 3-to-40-V Automotive-Use GaN Driver With Active Bootstrap Balancing and V SW Dual-Edge Dead-Time Modulation TechniquesIEEE Journal of Solid-State Circuits, 2020
- Direct 48-/1-V GaN-Based DC–DC Power Converter With Double Step-Down Architecture and Master–Slave AO2T ControlIEEE Journal of Solid-State Circuits, 2019
- Switched Tank ConvertersIEEE Transactions on Power Electronics, 2018
- Increasing Hyperscale Data Center Efficiency: A Better Way to Manage 54-V\/48-V-to-Point-of-Load Direct ConversionIEEE Power Electronics Magazine, 2017
- A 5MHz, 24V-to-1.2V, AO2T current mode buck converter with one-cycle transient response and sensorless current detection for medical meters2016
- A 5 MHz, 12 V, 10 A, monolithically integrated two-phase series capacitor buck converter2016