Inspection of Pitting Corrosions on Weld Overlay Cladding Using Uniform and Rotating Eddy Current Testing
- 30 August 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-10
Abstract
This study investigated the applicability of detecting pitting corrosions on stainless steel weld overlay cladding using uniform eddy current testing, which is insensitive to surface undulation, and rotating eddy current testing (RECT), which can be considered a superposition of uniform eddy current testing in orthogonal directions. The performance of the two techniques in detecting artificial pitting corrosions on and next to weld beads was compared. The signal distributions revealed that only RECT was capable of describing the surface profiles of pitting corrosions. The results of uniform eddy current testing could not distinguish between pitting corrosions and cracks. The probability of detection curves drawn to quantitatively indicate the detection capabilities of the two techniques revealed that uniform eddy current testing with induced eddy currents parallel and perpendicular to weld beads was better than RECT in detecting pitting corrosions on and next to weld beads, respectively. Scanning twice by uniform eddy current testing at orthogonal orientations may be a better process for detecting pitting corrosion on weld overlay cladding compared with using RECT. The measured signals of the two techniques in normal direction were located around the edges of the pitting corrosions, which only indicated the depth around edges. The results suggested that uniform eddy current testing and RECT with normal direction magnetic field signals may be inadequate for evaluating the maximum depth of pitting corrosions or large corrosions.Keywords
Funding Information
- National Natural Science Foundation of China (61903191)
- Natural Science Foundation of Jiangsu Province (BK20190422)
- Grant-in-Aid for JSPS Fellows (P19045)
- Fundamental Research Funds for the Central Universities (NJ2020014)
This publication has 29 references indexed in Scilit:
- Evaluation of the electromagnetic characteristics of type 316L stainless steel welds from the viewpoint of eddy current inspectionsJournal of Nuclear Science and Technology, 2013
- Assessment of Residual Stress Due to Overlay-Welded Cladding and Structural Integrity of a Reactor Pressure VesselJournal of Pressure Vessel Technology, 2013
- Automatic eddy current classification of signals delivered by flaws – application to nuclear fuel claddingInsight - Non-Destructive Testing and Condition Monitoring, 2012
- Pitting Corrosion of Bare Stainless Steel 304 under Chloride Solution DropletsJournal of the Electrochemical Society, 2010
- Development of computational inversion techniques to size cracks from eddy current signalsNondestructive Testing and Evaluation, 2009
- Some advances in numerical analysis techniques for quantitative electromagnetic nondestructive evaluationNondestructive Testing and Evaluation, 2009
- Eddy current inspection of closed fatigue and stress corrosion cracksMeasurement Science and Technology, 2007
- Application of eddy current inversion technique to the sizing of defects in Inconel welds with rough surfacesNuclear Engineering and Design, 2005
- Qualification of the LF-eddy current technique for the inspection of stainless steel cladding and applications on the reactor pressure vesselNuclear Engineering and Design, 2001
- Flaw detection ability of NDT techniques on clad surfaces of reactor pressure vesselsNuclear Engineering and Design, 1994