Experimental Study on the Welding Residual Stresses of Integral Joint Using Full-Scale Joint Model of a Steel Truss Bridge
Authors:
- 1 October 2013
- journal article
- Published by SAGE Publications in Advances in Structural Engineering
- Vol. 16 (10) , 1719-1727
Abstract
In order to study the residual stress distribution of the welded integral joint of steel truss bridge, a full-scale model was fabricated with the same welding process, same material as the real bridge in the bridge workshop. The residual stress state and distributions of residual stresses in the full-scale model were measured using blind-hole strain-gage method. The tested results show that high residual stress is caused during the welding process and the maximum tensile residual stress may reach the yield strength of the steel. Longitudinal tensile residual stress appears in the regions near the welding bead and changes to compressive stress at a certain distance from the welding bead, with the maximum tensile residual stress being in the centre of the welding bead. In butt-welding between two plates with different thicknesses, the value of welding residual stress in the thinner plate is lower than that of the thicker one. The results presented in this paper would be useful as references for developing measures of reducing the residual stress of integral joint in the fabrication of a real bridge.Keywords
This publication has 12 references indexed in Scilit:
- Residual stress measurement of a 316l stainless steel bead-on-plate specimen utilising the contour methodInternational Journal of Pressure Vessels and Piping, 2009
- Experimental and numerical analyses of residual stress distributions in TIG welding process for 304L stainless steelJournal of Materials Processing Technology, 2008
- Measurement of residual stresses in rails by neutron diffractionWear, 2008
- Measurement of residual stresses in cast aluminium engine blocksJournal of Materials Processing Technology, 2007
- Application of EDM Hole-Drilling Method to the Measurement of Residual Stress in Tool and Carbon SteelsJournal of Engineering Materials and Technology, 2006
- New technologies of steel bridges in JapanJournal of Constructional Steel Research, 2002
- Residual stress measurements in a cruciform welded joint using hole drilling and strain gaugesStrain, 1989
- Measurement of Non-Uniform Residual Stresses Using the Hole-Drilling Method. Part I—Stress Calculation ProceduresJournal of Engineering Materials and Technology, 1988
- Determination of Residual Stresses due to Girth-Butt Welds in PipesJournal of Pressure Vessel Technology, 1985
- Application of Finite Element Calculations to Residual Stress MeasurementsJournal of Engineering Materials and Technology, 1981