Inductive measurements of magnetic properties of ribbon materials
- 1 September 2004
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 75 (9) , 2817-2821
Abstract
Inductive measurements of thin ribbon materials are usually done with wrapped toroidal cores. To avoid this time consuming procedure, measurements can also be performed on short straight pieces in a solenoidal setup. We show that demagnetizing effects should be unimportant for the latter case in determining coercive field, saturation field, and core loss. These two types of measurement were performed on samples of amorphous ribbon material. It was found that there is reasonable agreement for these magnetic parameters as long as care was taken to ensure that the samples were strain-free. Strain is particularly important when the material has significant magnetostriction. Based on demagnetization estimates we would expect agreement on permeability determinations in all but the most extreme cases; in fact results can be quite different for the two measurements. Similarly, we can get rather different answers for coercive field when it is very small. This may be due to uniaxial anisotropy which is different for the two sample geometries. It is concluded that the rapid turnaround in solenoid measurements is particularly useful when optimization of saturation field or core loss is of primary importance.Keywords
This publication has 7 references indexed in Scilit:
- Magnetic characterization of soft magnetic materials—experiments and analysisJournal of Magnetism and Magnetic Materials, 2003
- Electromagnetic considerations in power electronic convertersProceedings of the IEEE, 2001
- Stress-induced anisotropy in Finemet- and Nanoperm-type nanocrystalline alloys using flash annealingJournal of Magnetism and Magnetic Materials, 2000
- Amorphous and nanocrystalline materials for applications as soft magnetsProgress in Materials Science, 1999
- A critical examination of the law of approach to saturation. I. Fit procedurePhysica Status Solidi (a), 1981
- Demagnetizing Factors of the General EllipsoidPhysical Review B, 1945
- Demagnetizing Factors of RodsJournal of Applied Physics, 1942