Boundary condition thermometry using a thermographic-phosphor-coated thin filament
Open Access
- 7 June 2016
- journal article
- Published by Optica Publishing Group in Applied Optics
- Vol. 55 (17) , 4691-4698
Abstract
Thermographic phosphors (TPs) exhibit a temperature sensitive emission spectrum when excited with ultraviolet radiation. In this study, 14 μm diameter SiC fibers are coated with ZnO or Dy:YAG using a ceramic binder to a total diameter of μm. ZnO and Dy:YAG fibers were used to measure fiber temperatures in the range of 294–450 K and 450–1245 K, respectively. The coated fiber provides higher signal levels compared to TP particle seeding and is no more invasive than the commonly used thermocouple. A calibration is performed to relate fiber temperature to the ratio of luminescent signal collected within two different bands of the fiber emission spectrum. Temperature was measured along the inlet of a series of nitrogen diluted ethylene diffusion flames stabilized on the Yale coflow burner to determine suitable thermal boundary conditions for computational modeling. The boundary condition temperatures were derived from a spline fitting of data acquired from the two fiber types in order to obtain fiber temperature sensitivity from 294 to 1245 K. The peak near-burner temperature was found to be higher than ambient conditions and to increase and shift its location radially outward with increased fuel percentage.
Keywords
Funding Information
- National Science Foundation (NSF) (CBET-1403224)
This publication has 36 references indexed in Scilit:
- Laminar counterflow steady diffusion flames under high pressure (P⩽ 3 MPa) conditionsCombustion and Flame, 2012
- A comparison of Raman signatures and laser-induced incandescence with direct numerical simulation of soot growth in non-premixed ethylene/air flamesCarbon, 2011
- Thermographic phosphors for thermometry: A survey of combustion applicationsProgress in Energy and Combustion Science, 2011
- Soot and thin-filament pyrometry using a color digital cameraProceedings of the Combustion Institute, 2011
- Survivability of thermographic phosphors (YAG:Dy) in a combustion environmentMeasurement Science and Technology, 2010
- Soot formation in laminar diffusion flamesCombustion and Flame, 2005
- Computational and experimental study of soot formation in a coflow, laminar diffusion flameCombustion and Flame, 1999
- Thin-filament pyrometry in flickering laminar diffusion flamesSymposium (International) on Combustion, 1996
- Thin filament infrared pyrometry: instantaneous temperature profile measurements in a weakly turbulent hydrocarbon premixed flameExperiments in Fluids, 1994
- Temperature measurements by light-scattering methodsProgress in Energy and Combustion Science, 1988