Passive filter design supporting a star-like joint-connector-based topology in high-speed controller area networks
Authors:
- 10 June 2013
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 227 (9) , 1337-1347
Abstract
In this paper, a passive filter is proposed to support a star-like topology in a high-speed controller area network and to extend the length of the stubs. A high-speed controller area network requires a linear wiring topology, while an actual network may be configured as a star-like structure using joint connectors owing to productivity and cost concerns. This joint-connector-based controller area network configuration is likely to suffer from increased signal distortions caused by a larger transient voltage and impedance mismatch. Here, a passive filter for reducing these signal distortions in a joint-connector-based controller area network structure is proposed, which allows a star-like topology with extended stubs. The proposed passive filter is composed of a resistor and bead in series, which is easily inserted in a joint connector. With the proposed filter, the induced transient voltage and settling time in transition to a recessive state were reduced by 37% and 66% respectively. Thus, the proposed filter has the effect of improving the reliability of communication in the same wiring dimension or, equivalently, lengthening the stubs with the same reliability.Keywords
This publication has 8 references indexed in Scilit:
- Passive filter design supporting a star-like joint-connector-based topology in high-speed controller area networksProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2013
- Design and Verification of a Media Redundancy Management Driver for a CAN Star TopologyIEEE Transactions on Industrial Informatics, 2012
- Frequency-Domain Analysis of Effects of a Diverged Interconnect Design Involved in High-Speed Front-End ElectronicsIEEE Transactions on Instrumentation and Measurement, 2010
- Quantitative Comparison of the Error-Containment Capabilities of a Bus and a Star Topology in CAN NetworksIEEE Transactions on Industrial Electronics, 2009
- An Active Star Topology for Improving Fault Confinement in CAN NetworksIEEE Transactions on Industrial Informatics, 2006
- Shunt stub line impedance matching: a wave reflection analysis tutorialIEEE Antennas and Propagation Magazine, 2002
- A new CAN-like field network based on a star topologyComputer Standards & Interfaces, 2001
- CAN Bit Timing RequirementsSAE International Journal of Advances and Current Practices in Mobility, 1997