Structural heterogeneity and its effects on the properties of an in situ TiB2–TiC/Cu composite synthesised by hot pressing
Authors:
- 14 March 2020
- journal article
- research article
- Published by SAGE Publications in Powder Metallurgy
- Vol. 63 (2) , 126-133
Abstract
In situ TiB2 and TiC reinforced copper matrix composites with tailored heterogeneous structure were fabricated via high-energy ball milling of Cu, TiH2 and B4C powders followed by hot pressing. The microstructures of both ball-milled powders and hot-pressed composites were compared. Although the dislocation density of Cu matrix was changed after hot pressing, the mode of distribution of ceramic phases in the Cu matrix was noted to transmit from the ball-milled powders to hot-pressed composites in case of the TiH2 particles synthesised by the in situ reactions. The structural inheritance between the ball-milled powders and hot-pressed composites could be used to control microstructural features and thus to tune properties. The hot-pressed TiB2–TiC/Cu composites with tailored heterogeneous structure exhibited better performance than those of homogeneous counterparts.Keywords
This publication has 26 references indexed in Scilit:
- Increase in dislocation density in cold-deformed Pd using H as a temporary alloying additionScripta Materialia, 2013
- Mechanical alloying and sintering of nanostructured tungsten carbide-reinforced copper composite and its characterizationMaterials & Design (1980-2015), 2011
- Effects of milling time on hardness and electrical conductivity of in situ Cu–NbC composite produced by mechanical alloyingJournal of Alloys and Compounds, 2009
- Reaction path of the synthesis of TiC–TiB2 in Cu–Ti–B4C systemInternational Journal of Refractory Metals and Hard Materials, 2008
- Mechanical and electrical properties of Cu–Ta nanocomposites prepared by high-energy ball millingActa Materialia, 2007
- Correlation between milling parameters and microstructure characteristics of nanocrystalline copper powder prepared via a high energy planetary ball millJournal of Alloys and Compounds, 2007
- Performance and characterization of dispersion strengthened Cu–TiB2 composite for electrical useMaterials Characterization, 2005
- The solubility of C in solid CuScripta Materialia, 2004
- Diffusion parameters of B in Cu determined by β-radiation-detected NMRPhysical Review B, 2001
- III. Dislocation densities in some annealed and cold-worked metals from measurements on the X-ray debye-scherrer spectrumPhilosophical Magazine, 1956