Simulation of adsorber tube diameter’s effect on new design silica gel-water adsorption chiller
- 1 January 2017
- conference paper
- Published by AIP Publishing
Abstract
A new design of silica gel-water adsorption chiller is proposed. The design configuration is composed of two sorption chambers with compact fin tube heat exchangers as adsorber, condenser, and evaporator. Heat and mass recovery were adopted in order to increase the cooling capacity. Numerical modelling and calculation were used to show the performance of the chiller with different adsorber tube diameter. Under typical condition for hot water inlet/cooling water inlet/chilled water outlet temperatures are 90/30/7°C, respectively, the simulation results showed the best average value of COP, SCP, and cooling power are 0.19, 15.88 W/kg and 279.89 W using 3/8 inch tube.Keywords
This publication has 14 references indexed in Scilit:
- Numerical Simulation of a Two-bed Solar-driven Adsorption Chiller in a Tropical ClimateInternational Journal of Technology, 2015
- Review and future trends of solar adsorption refrigeration systemsRenewable and Sustainable Energy Reviews, 2014
- A stand-alone solar adsorption refrigerator for humanitarian aidSolar Energy, 2014
- Study on a compact silica gel–water adsorption chiller without vacuum valves: Design and experimental studyApplied Energy, 2010
- A new cycle time allocation for enhancing the performance of two-bed adsorption chillersInternational Journal of Refrigeration, 2009
- Design and performance of a solar-powered heating and cooling system using silica gel/water adsorption chillerApplied Thermal Engineering, 2009
- A review on adsorption working pairs for refrigerationRenewable and Sustainable Energy Reviews, 2009
- Review of solar sorption refrigeration technologies: Development and applicationsRenewable and Sustainable Energy Reviews, 2007
- Adsorption refrigeration—An efficient way to make good use of waste heat and solar energy☆Progress in Energy and Combustion Science, 2006
- Study of a novel silica gel–water adsorption chiller. Part I. Design and performance predictionInternational Journal of Refrigeration, 2005