EXPERIMENTAL ANALYSIS OF TEMPERATURE IN GRINDING AT THE GLOBAL AND LOCAL SCALES
- 7 March 2008
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 12 (1) , 1-14
Abstract
The purpose of the article is the experimental estimation of the global and local heat fluxes and the corresponding energy partition to the workpiece for regular grinding of 100Cr6 steel with aluminium oxide wheel. By using a grindable thermocouple, the temperature and the real contact length allow determination of the global heat flux and the partition ratio at the wheel scale. The high frequency analysis of the signal has shown maximum flash temperatures of about 1000°C corresponding to the local temperature under the chip-grain unit with very high heating speed of about 100°C/µs. The comparison between theoretical temperature decay and experimental cooling has demonstrated that the time response of the sensor is fast enough for the estimation of the local temperature and power due to the sliding of grain and to the plastic strain of ground materials.Keywords
This publication has 4 references indexed in Scilit:
- Numerical analysis of grinding temperature measurement by the foil/workpiece thermocouple methodInternational Journal of Machine Tools and Manufacture, 2006
- Comparison of Methods to Measure Grinding TemperaturesJournal of Manufacturing Science and Engineering, 2000
- Temperature control in CBN grindingThe International Journal of Advanced Manufacturing Technology, 1996
- Measurement of Grinding Temperature of Active Grains Using Infrared Radiation Pyrometer with Optical FiberCIRP Annals, 1993