Wind-Tunnel Simulation of Approximately Horizontally Homogeneous Stable Atmospheric Boundary Layers
Open Access
- 21 April 2021
- journal article
- research article
- Published by Springer Nature in Boundary-Layer Meteorology
- Vol. 180 (1) , 5-26
Abstract
Two cases of an overlying inversion imposed on a stable boundary layer are investigated, extending the work of Hancock and Hayden (Boundary-Layer Meteorol 168:29–57, 2018; 175:93–112, 2020). Vertical profiles of Reynolds stresses and heat flux show closely horizontally homogeneous behaviour over a streamwise fetch of more than eight boundary-layer heights. However, profiles of mean temperature and velocity show closely horizontally homogeneous behaviour only in the top two-thirds of the boundary layer. In the lower one-third the temperature decreases with fetch, directly as a consequence of heat transfer to the surface. A weaker effect is seen in the mean velocity profiles, curiously, such that the gradient Richardson number is invariant with fetch, while various other quantities are not. Stability leads to a ‘blocking’ of vertical influence. Inferred aerodynamic and thermal roughness lengths increase with fetch, while the former is constant in the neutral case, as expected. Favourable validation comparisons are made against two sets of local-scaling systems over the full depth of the boundary layer. Close concurrence is seen for all stable cases for z/L < 0.2, where z and L are the vertical height and local Obukhov length, respectively, and over most of the layer for some quantities.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/N508512/1, EP/N006224/1)
This publication has 27 references indexed in Scilit:
- Gradient‐based scales and similarity laws in the stable boundary layerQuarterly Journal of the Royal Meteorological Society, 2010
- The rough-wall turbulent boundary layer from the hydraulically smooth to the fully rough regimeJournal of Fluid Mechanics, 2007
- A wind tunnel study of dense gas dispersion in a neutral boundary layer over a rough surfaceAtmospheric Environment, 2001
- The design of spires for wind simulationJournal of Wind Engineering and Industrial Aerodynamics, 1981
- The development of turbulent thermal layers on flat platesInternational Journal of Heat and Mass Transfer, 1979
- Adiabatic atmospheric boundary layers: A review and analysis of data from the period 1880–1972Atmospheric Environment (1967), 1975
- Simulation of an adiabatic urban boundary layer in a wind tunnelAtmospheric Environment (1967), 1973
- Further measurements in a simulated atmospheric boundary layerAtmospheric Environment (1967), 1970
- An improved method of simulating an atmospheric boundary layer in a wind tunnelAtmospheric Environment (1967), 1969
- The simulation of the atmospheric boundary layer in a wind tunnelAtmospheric Environment (1967), 1968