A 2.5–25-GHz 10:1 Bandwidth Eight-Channel Rx Beamformer Chip Based on Quad-Pole I/Q Network for Ultra-Wideband Systems
- 3 September 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 61 (5) , 1961-1973
Abstract
This article presents an ultra-wideband quad-pole $I/Q$ network and its implementation in a 10:1 bandwidth beamformer receiver from 2.5 to 25 GHz. Unlike conventional quadrature all-pass filter (QAF) network with second-order response, this design uses a voltage-to-current (V–I) conversion architecture to achieve a fourth-order quadrature phase response, maintaining a $\lt \pm 5^{\circ } $ phase error over a decade of bandwidth. The network also features third-order IQ gain error response with low conversion loss, making it an ideal candidate for beamformer designs. A circuit implementation of the V– $I~IQ$ network on an ultra-wideband phase shifter is presented using a high-linearity common-base (CB) vector modulator (VM). To demonstrate the efficacy of this design, a single-channel beamforming receiver and an eight-channel beamformer were fabricated and measured. The channel is measured to have an rms phase error of 2.7° at 2.5–25 GHz without any calibration. The eight-channel beamformer chip shows an IP1dB of −28 to −25 dBm with a channel NF of 2.5–4 dB at 2.5–25 GHz. For base station applications, a 16-element linear array using Vivaldi antennas is also presented, demonstrating the ultra-wideband capabilities of this design and confirming its feasibility for future sixth-generation (6G) FR3 systems.
Keywords
Funding Information
- CACI Inc
This publication has 32 references indexed in Scilit:
- K/Ka-Band Hybrid-Packaged Four-Element Four-Beam Phased-Array Transmitter and Receiver Front-Ends With Optimized Beamforming Passive NetworksIEEE Journal of Solid-State Circuits, 2024
- A Low-Power 256-Element Ka-Band CMOS Phased-Array Receiver With On-Chip Distributed Radiation Sensors for Small Satellite ConstellationsIEEE Journal of Solid-State Circuits, 2023
- 19.4 A Small-Satellite-Mounted 256-Element Ka-Band CMOS Phased-Array Transmitter Achieving 63.8dBm EIRP Under 26.6W Power Consumption Using Single/Dual Circular Polarization Active Coupler2023
- A 39-GHz CMOS Bidirectional Doherty Phased- Array Beamformer Using Shared-LUT DPD With Inter-Element Mismatch Compensation Technique for 5G Base StationIEEE Journal of Solid-State Circuits, 2023
- A 24-to-30GHz 256-Element Dual-Polarized 5G Phased Array with Fast Beam-Switching Support for >30,000 Beams2022
- A Multi-Band 16–52-GHz Transmit Phased Array Employing 4 × 1 Beamforming IC With 14–15.4-dBm P sat for 5G NR FR2 OperationIEEE Journal of Solid-State Circuits, 2021
- A CMOS Dual-Polarized Phased-Array Beamformer Utilizing Cross-Polarization Leakage Cancellation for 5G MIMO SystemsIEEE Journal of Solid-State Circuits, 2021
- A 28-GHz CMOS Phased-Array Transceiver Based on LO Phase-Shifting Architecture With Gain Invariant Phase Tuning for 5G New RadioIEEE Journal of Solid-State Circuits, 2019
- A 25–30 GHz Fully-Connected Hybrid Beamforming Receiver for MIMO CommunicationIEEE Journal of Solid-State Circuits, 2018
- A Low-Cost Scalable 32-Element 28-GHz Phased Array Transceiver for 5G Communication Links Based on a $2\times 2$ Beamformer Flip-Chip Unit CellIEEE Journal of Solid-State Circuits, 2018