Influence of Acrylic Adhesive Viscosity and Surface Roughness on the Properties of Adhesive Joint
- 15 July 2015
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 92 (11) , 877-891
Abstract
In adhesion, the wetting process depends on three fundamental factors: the surface topography of the adherend, the viscosity of the adhesive, and the surface energy of both. The aim of this paper is to study the influence of viscosity and surface roughness on the wetting and their effect on the bond strength. For this purpose, an acrylic adhesive with different viscosities was synthesized and some properties, such as viscosity and surface tension, were studied before adhesive curing took place. Furthermore, the contact angle and the lap-shear strength were analyzed using aluminum adherends with two different roughnesses. Scanning electron microscopy was used to determine the effect of the viscosity and the roughness on the joint interface. The results showed that the adhesive exhibits an optimal value of viscosity. Below this value, at low viscosities, the low neoprene content produces poor bond strength due to the reduced toughness of the adhesive. Additionally, it also produces a high shrinkage during curing, which leads to the apparition of residual stresses that weakens the interfacial strength. However, once the optimum value, an increase in the viscosity produces a negative effect on the joint strength as a result of an important decrease in the wettability.Keywords
This publication has 21 references indexed in Scilit:
- Effect of Mechanical Surface Treatment on the Static Strength of Adhesive Lap JointsThe Journal of Adhesion, 2013
- Influence of Surface Preparation on the Fracture Behavior of Acrylic Adhesive/CFRP Composite JointsThe Journal of Adhesion, 2011
- Modeling the rheology of anaerobic adhesive formulationsJournal of Adhesion Science and Technology, 2006
- Adhesive bonding of aluminium with structural acrylic adhesives: durability in wet environmentsJournal of Adhesion Science and Technology, 2006
- Surface energy, surface topography and adhesionInternational Journal of Adhesion and Adhesives, 2003
- A study on the effects of surface roughness on the strength of single lap jointsJournal of Adhesion Science and Technology, 2001
- The effects of grit-blasting on surface properties for adhesionInternational Journal of Adhesion and Adhesives, 1999
- Durability modelling concepts and tools for the cohesive environmental degradation of bonded structuresInternational Journal of Adhesion and Adhesives, 1997
- Influence of surface macroroughness on the durability of epoxide-aluminium jointsInternational Journal of Adhesion and Adhesives, 1995
- Contact angle, wetting, and adhesion: a critical reviewJournal of Adhesion Science and Technology, 1992