Optimization of electrospun chitosan/polyethylene oxide hybrid nanofibril composite via response surface methodology
- 3 July 2023
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 37 (3) , 885-909
Abstract
The present study is an attempt to optimize the electrospinning parameters to fabricate chitosan/polyethylene oxide hybrid nanofiber composite with minimum diameter and coefficient of variation (homogeneity) by using response surface methodology (RSM). Based on central composite design (CCD), four factors (the chitosan/PEO ratio, the applied voltage, the needle-to-collector distance, and the spinning angle) was applied to evaluate the individual and combined effects of the parameters on the average diameter of nanofibers. Chitosan (CH) was blended with Polyethylene oxide (PEO) at weight ratios of 1:1, 2:1, 3:1, 4:1, and 5:1. As the composition ratio of chitosan was reduced, the viscosity of the chitosan/PEO blend solution also dropped. The RSM model identified the following conditions as necessary to produce the desired and most uniform CS/PEO fiber diameter: a CS/PEO blend ratio of 2:1 (w/w), a voltage of 25 kV, a distance of 20 cm, and a spinning angle of 45°. The average nanofiber diameter and homogeneity under these conditions were calculated to be 73 nm and 20.5%, respectively, compared to the predicted values of 71 nm and 15.58%, respectively.Keywords
This publication has 42 references indexed in Scilit:
- Core–Shell Structured PEO-Chitosan Nanofibers by Coaxial ElectrospinningBiomacromolecules, 2012
- A fundamental study of chitosan/PEO electrospinningPolymer, 2011
- Characterization of PVA-Chitosan Nanofibers Prepared by ElectrospinningProcedia Engineering, 2011
- Preparation of chitosan/PLA blend micro/nanofibers by electrospinningMaterials Letters, 2009
- Electrospinning of chitosan–poly(ethylene oxide) blend nanofibers in the presence of micellar surfactant solutionsPolymer, 2009
- Response surface methodology (RSM) as a tool for optimization in analytical chemistryTalanta, 2008
- Modeling and optimization I: Usability of response surface methodologyJournal of Food Engineering, 2007
- Fabrication and characterization of poly (vinyl alcohol)/chitosan blend nanofibers produced by electrospinning methodCarbohydrate Polymers, 2007
- Electro-spinning optimization for precursor carbon nanofibersComposites Part A: Applied Science and Manufacturing, 2006
- Alginate‐Based Nanofibrous Scaffolds: Structural, Mechanical, and Biological PropertiesAdvanced Materials, 2006