An adjacency-based test pattern generator for low power BIST design
Authors:
- L. GuillerLGL. Guiller
- C. LandraultCLC. Landrault
- S. PravossoudovitchSPS. Pravossoudovitch
- 8 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10817735,p. 459-464
Abstract
A new BIST TPG design that is comprised of an Adjacency-based TPG plus a conventional pseudo-random TPG (i.e. a LFSR) is presented in this paper. When used to generate test patterns for test-per-clock BIST, it reduces the number of transitions that occur in the CUT and hence decreases the average and peak power consumption during testing. Moreover, the total energy consumption during BIST is also reduced since the test length produced by the mixed TPG is roughly the same as the test length produced by a classical LFSR-based TPG to reach the same fault coverage. Note that this TPG design has been developed to deal with strongly connected circuits with a small number of inputs.Keywords
This publication has 14 references indexed in Scilit:
- Circuit partitioning for low power BIST design with minimized peak power consumption2003
- A test vector inhibiting technique for low energy BIST design2003
- LT-RTPG: a new test-per-scan BIST TPG for low heat dissipation2003
- Minimized power consumption for scan-based BIST2003
- Combinational profiles of sequential benchmark circuits2003
- A distributed BIST control scheme for complex VLSI devices2002
- Iddq test: sensitivity analysis of scaling2002
- Power constraint scheduling of tests2002
- DS-LFSR: a new BIST TPG for low heat dissipation2002
- Power minimization in IC designACM Transactions on Design Automation of Electronic Systems, 1996