Control of the Mg-Treated Iron Casting Skin Formation by S-Diffusion Blocking at the Metal–Mould Interface
Open Access
Abstract
Having established that sulphur presence in the mould materials appears to have an important contribution in graphite degeneration at least in the casting surface layer, a research program is undertaken to explore the possible beneficial effect of sulphur diffusion blocking at the metal–mould interface. Test samples, with and without a thin steel sheet (up to 3 mm thickness) application on the inner surface of the mould cavity, before iron melt pouring, are considered for structure analysis. A higher nodulizing potential (0.048% Mgres, 0.015% Ceres, and 0.006% Lares) decreases the occurrence of surface graphite degeneration in castings obtained in rigid chemically bonded resin sand moulds, using P-toluol sulfonic acid (PTSA) hardener (S-including), but it is not enough to avoid this phenomenon (200–400 μm skin in present experimental conditions). The casting skin appears to have different values, depending on the evaluation technique (un- and Nital-etching direct measurement, or graphite parameters variation on the casting section). In the presence of a thin steel sheet at the metal–mould interface, the casting skin thickness decreases or is just excluded. It is supposed that it acts as a barrier, blocking S-diffusion from the mould media into the iron melt. Without this S-diffusion, the graphite degeneration in the casting surface layer could be avoided, or at least diminished. For industrial application, the increasing of residual content of nodulizing elements is a limited solution, and it is recommended to use barriers to block S transfer on the mould/metal surface, such as dense coatings or coatings with desulphurization capacity.Keywords
Funding Information
- European Social Fund Plus (Financial agreement 51668/09.07.2019, SMIS code 124705)
This publication has 16 references indexed in Scilit:
- Graphite Degeneration in High Si, Mg-Treated Iron Castings: Sulfur and Oxygen Addition EffectsInternational Journal of Metalcasting, 2019
- Integrated System of Thermal/Dimensional Analysis for Quality Control of Metallic Melt and Ductile Iron Casting SolidificationJournal of Materials Engineering and Performance, 2018
- Occurrence and effect of casting skin in compacted graphite ironInternational Journal of Cast Metals Research, 2016
- Effect of the Quality of Furan Moulding Sand on the Skin Layer of Ductile Iron CastingsISIJ International, 2014
- Mg bearing coating of resin sand–PTSA moulds to control graphite degeneration in surface layer of ductile iron castingsMaterials Science and Technology, 2012
- Mold Coatings to Reduce Graphite Degeneration in the Surface Layer of Ductile Iron CastingsInternational Journal of Metalcasting, 2012
- Influence of Magnesium Content and Coating Type on Graphite Degeneration in Surface Layer of Iron Castings in Resin Sand ^|^ndash; P-Toluol Sulphonic Acid (PTSA) MouldsISIJ International, 2012
- Solidification of Thin Wall Ductile Iron Castings with Hypereutectic CompositionISIJ International, 2010
- Quantification of Casting Skin in Ductile and Compacted Graphite Irons and Its Effect on Tensile PropertiesInternational Journal of Metalcasting, 2008
- Comparative Study of Fatigue Endurance Limit for 4 and 6 mm Thin Wall Ductile Iron CastingsInternational Journal of Metalcasting, 2008